Ventilation Hood User Manual

CONVERTIBLE KITCHEN RANGE HOOD
FOR 120 V. OPERATION
KITCHEN
RANGE HOOD
MODEL
FOR VENTLESS INSTALLATION
USE DUCTLESS KIT RCH 9600
RH9330XL
READ AND SAVE THESE INSTRUCTIONS
Before you begin,
read the following instructions
completely and carefully. If followed, they will simplify
the installation job.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
WAYS TO INSTALL VENTILATING DUCT:
There are three ways to install the ventilating duct.
Select the most practical method for your particular
installation.
Figure 7: 7” dia. round venting through the roof.
Figure 8: Transition, from the 7” dia. stack provided
on the hood to a 3 l/4 x 10 rectangular duct, for roof
venting.
Figure 9: 7” dia. elbow, for horizontal venting, with
a wall cap.
\FAN BOX MOUNTING
SCREWS (6)
FIGURE 1
The duct, wall cap and roof cap shown in Figure 7,8
and 9 are not included with your range hood
These Items can be purchased separately.
TOOLS AND MATERIALS REQUIRED
A---
l Drill, electric or ratchet drive, with 3/8”, 3/16” and l/8”
F
:r
-;*/
wood brt (for drlllrng starter holes) and l-1/4” wood bit
(to drill an access hole in the cabinet or kitchen wall for
C”
the electrrc power line.)
l One common and one ohllllps head screwdriver (to
secure hood mounting screws to the cabinet and hood
sheet metal parts).
l Pliers (for opening knockouts).
l Pencil, ruler and level for marking cabinet locattons.
l Saber saw or keyholesaw for cutting the wall or cabinet
openings.
l Caulkrng, metal snips, duct tape, ducts (with elbow and
transitron, If necessary) and wall cap or roof cap, as
required.
A626-127 830878
Page 1
3-17-82