TABLE OF CONTENTS OVEN SAFETY ELECTRONIC OVEN CONTROL. Display. Start... Aluminum Foil. Positioning Racks and Bake ware Bake ware. Meat Thermometer, Oven Vent... Baking and Roasting. Broiling and Custom Br Timed Cooking OVEN CARE... Self-Cleaning Cycle {on some mode General Cleaning Given Lights Oven Door TROUBLESHOOTING ASSISTANCE OR SERVICE. WARRANTY TABLE DES MATTRESSES SECURITY DU COMMAND ELECTRONIC DU FOUR Muse en march Off/Cancel (tintinnabulation) Horology Sign aux snores Fahrenheit et Celsius.
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electrical shack, injury to persons, or damage when using the oven, follow basic precautions, including the following: @ Proper Installation — Be sure the oven is properly installed and grounded by a qualified technician, Aver Use the Oven for Warming or Heating the Boom, Do Not Leave Children Alone — Children should not be left alone or unattended in area where oven is in use, They should never be allowed 1o sit or stand on any part of the
ELECTRONIC OVEN CONTROL Bean OOO DOC De® @®OC So a oy Wickerwork oven Oven setting pas B, Temperature pads C. Oven light D. Auto clean E. Electronic display H. Hour pad 1. Minute pad F Microwave oven controls Q, Electronic sock control J Timer set and off K. Clack pad L. Start pad M. Lower oven officialese Thursday When power is first supplied to the appliance, “PF” will appear on the display. Press LOWER OFF/CANCEL to clear. If “PE” appears at any other time, a power failure has occurred.
All Tones All of the above tones are preset on. All except the end-of-cycle tones can be turned off. Fo Turn Off/On: Press and hold STOP TIME for 5 seconds. A tone will sound, and “OFF” or “8nd OFF” {depending on your remodel} will appear on the display, Repeat to change back to “on” or “8nd On” {depending on your model), Reminder Tones Reminder tones are four 1-second tones which indicate that the set time has expired for a timer or a timed oven control function.
OVEN USE Odors and smoke are normal when the oven is used the first few times, or when it is heavily soiled. IMPORTANT: The health of some birds is extremely sensitive to the fumes given off. Exposure to the fumes may result in death to certain birds. Always move birds to another closed and well ventilated room.
Sent Thermos On models without a temperature probe, use a meat thermometer to determine whether meat, poultry and fish, are cooked to the desired degree of oneness. The internal temperature, not appearance, should be used to determine oneness. A meat thermometer is not supplied with this appliance. Follow manufacturer's directions for using a meat thermometer. Upper vane B. Overs vent C.
BROILING CHART For bast results, place food more from the broil lament. Times are guidelines only and may need to be adjusted for individual tastes. Recommended rack positions are numbered farm the bottom {1} to the top (5). For diagram, see the “Positioning Racks and Bake ware” section. Approximate Time RACK {minutes} FOOD POSITION gpg 1 SIDE 2 Steak 1° {2.
Hpi Ge hit, Burn Hazard Do not touch the oven during the Self-Cleaning cycle. Keep children away from oven during Self-Cleaning cycle. Failure to follow these instructions can result in burns. IMPORTANT: The health of some birds is extremely sensitive to the fumes given off during the Self-Cleaning cycle. Exposure to the fumes may result in death to certain birds, Always move birds to another closed and well-ventilated room Self-clean the oven before it becomes heavily soiled.
2. Press STOP TIME. 3. Press the HOUR and MIN or keypads to enter the time of day to stop. 4. Press START. The start time is automatically calculated and displayed. The door will lock automatically, and “LOCKED” and “DELAY” will appear on the display. The door will not unlock until the oven cools. ‘When the start time is reached, the vane will turn on automatically. When the cycle is complete and the oven cools, “End” will appear on the lower oven display and “LOCKED” will disappear, 5.
The oven lights are standard 15-watt appliance bulbs. They will come on when the oven door is opened, They will not work during the Self-Cleaning cycle. When the oven door is closed. press OVEN LIGHT to turn therm on or off. To Replace: Before replacing, make sure the oven is off and cool. 1. Disconnect power. 2. Tum the glass bulb cover in the back of the oven counterclockwise to remove. 3. Tum bulb counterclockwise to remove from socket. 4. Replace bulb and bull cover by turning clockwise. 8.
TROUBLESHOOTING Try the solutions suggested here first in order to avoid the cost of an unnecessary service call. Nothing will operate Self-Cleaning cycle will not operate w Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse ar reset the circuit breaker. if the problem continues, call an electrician. mis the appliance wired properly? See Installation Instructions. Even will not operate mis the electronic oven control sef correctly? See “Electronic Oven Control” section.
ASSISTANCE OR SERVICE Before calling for assistance or service, please check “Troubleshooting.” it may save you the cost of a service call, if you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond fo your request. If you need replacement parts If you need to order replacement parts, we recommend that you use only FSP? replacement parts.
WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For one year from the date of purchase. when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP thereafter “Whirlpool) will pay for Factory Specified Parts and repair labor to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company.
SÉCURITÉ DU FOUR Votre sécurité et celle des autres est trais importante. Nous dormons de nombreux messages de sécurité importants dans ce manuel st sur voler appareil ménager. Assurez-vous de toujours lire tous les messages de sécurité et de vous y conformer. Voici le symbole d'alerte de sécurité Ce symbole d'alerte de sécurité vous signale les dangers potentiels de décès ef de blessures graves a vous et a d’autres.
COMMANDE électronique DU FOUR Ben OOO in ¥ DOC De® @®OC Swe a co wn wos loden vies distomatose aven Touches pour le réglage du four B, Touches de température ©. Lampe du four D. Auto nettoyage E. Affichage Électroniques £ Commandes du four & micro-ondes G. Commande électronique de horloge H. Touche des heures 1. Touche des minutes J Minuterie ~ Réglage of arrêt K. Touche de horloge L. Touche de mise en marche M.
Les signaux sonates indiquent ce qui suit: Lin signal sonore m Appui sur une touche valide w Four préchauffé w Fonction entrée Trois signaux sonores wm Appui sur une touche non valide Quatre signaux sonores m Fin du programme um Signaux de rappel émis & intervalles de une minute après les signaux de fin de programme Tous les signaux sonores Tous les signaux sonores ci-dessus sont préréglés a on (marche), Tous sauf les signaux sonores de fin de programme peuvent être désactivés.
FOE CO Le verrouillage des commandes désactive les touches du tableau de commande pour empêcher Utilisation involontaire du four, Lorsque fa commande ast verrouillée, seules les touches de Perforage et de la minuterie fonctionnent. Pour verrouiller/déverrouiller les commandes : Avant de verrouiller, s'assurer que le four et la minuterie sont désactivés. Appuyer sur la touche STAR (mise en marche) pendant 5 secondes.
USTENSILES DE CUISSON L'air chaud doit pouvoir circuler autour de Aliment pour le cuire uniformément, de telle sorte qu'il faut laisser 2” (5 om) entre les ustensiles de cuisson et les parvis du four. Se servir du tableau suivant comme guide, NOMBRE D'USTENSILES POSITIONNEMENT SUR LA GRILLE 1 Centre de la grille. 2 Cote a cote ou légèrement décalés, oud Dans les coins opposés sur chaque grille.
Cuisson au four ou rôtissage : 1. Appuyer sur BAQUE (cuisson au four). Appuyer sur les touches TEMPE “plus” ou “moins” pour entra une température autre que 350°F (177°C) par tranches de 5°, La température de cuisson au four pot tre réglée entre 170°F et S00°F (77°C et 260°C). 2. Appuyer sur STAR (mise en marche). La température peut être changée paras cette étape. ll n’est pas nécessaire d'appuyer de nouveau sur Stuart. 3. Appuyer sur LOSER ANGELINO (rétrorégulation du four inférieur) après avoir termine.
Unisson numide article toa id Risque d'empoisonnement alimentaire Ne pas laisser des aliments dans un four plus d'une heure avant ou après la cuisson. Le non-respect de celle instruction peut causer un empoisonnement alimentaire ou une maladie. La cuisson minutée permet d'allumer le four & une certaine heure de la journée, de faire cuire pendant une durée réglée atout d'éteindre le four automatiquement.
ENTRETIEN DUFOUR UN occire Hoo Lhd, Risque de brisures Ne pas toucher le four au cours du programme autonettoyante. Garder les enfants loin du four au cours du programme autonettoyante. Le non-respect de ces instructions peut causer des bittures, IMPORTANT : La santé de certains oiseaux est trais sensible aux émanations qui surviennent durant le programme autonettoyante. L'exposition aux émanations peut entraîner la mort de certains aixoise.
2. Appuyer sur STOP ITEM heure d’arrérages. 3. Appuyer sur les touches a fléchés GOUR ef MIN “plus” ou “moins” pour entrer ['heure d’arrêt. 4. Appuyer sur STAR (mise en marche). Lu heure de mise en marche est automatiquement calculée et affichée. La porte se verrouille autocratiquement et “LOCKE” (porte verrouiller, “DÉLAI” (délai). apparaîtront sur Afficheur. La porte ne se déverrouille pas avant que le four ait refroidi. Lorsque Heure de mise en marche sera atteinte. le four s'allumera automatiquement.
¥ i hed Lectine Les lampes du four ont des ampoules d’appareil ménager standard de 15 watts, Elles s’allument lorsque la porte du four est ouverte. Elles ne fonctionneront pas durant le programme autonettoyante. Lorsque la porte du four est fermée, appuyer sur OVE LIGHT (lampe du four) pour les allumer ou les éteindre. Remplacement : Avant le remplacement, s'assurer que le four est éteint af froid. 1. Déconnecter la source de courant électrique. 2.
DÉPANNAGE Essayer d'abord les solutions suggérées ici afin d'éviter le colt d'une visite de service non nécessaire. Rien ne fonctionne wm Infusible est-i grillé iule déclenché? Remplacer le fusible ou réenclencher le disjoncteur. Aile problème persiste, appeler un électricien. wm Appareil est-il correctement raccordé? Voir les instructions d'installation. Le four ne fonctionne pas m La commande électronique du four est-elle correctement réglée? Voir la section “Commande électronique du four”.
ASSISTANCE OU SERVICE Avant de faire un appel pour assistance ou service, consulter la section “Dépannage”. Ce guide peut vous faire ergonomiste le colt d'une visite de service. Si vous avez encore besoin d'aide, suivre les instructions ci-dessous. Lors d'un appel, veuillez connaître la date d’achat, le numéro de modale et le numéro de série au complet de l'appareil. Ces renseignements nous aideront & mieux répondre a votre demande.
GARANTIE DES GROS APPAREILS MÉNAGERS WHIRLPOOL CORPORATION GARANTIE LIMITÉE Pendant un an a compter de la date d'achat, lorsque ce gros appareil] ménager est utilisé et entretenu conformément aux instructions jointes a ou fournies avec le produit, Whirlpool Corporation ou Whirlpool Canada LP {ci-après désignées “Whirlpool” paiera pour les pièces spécifies par F'usine et la pour carrier les vices de matériaux ou de fabrication. Le service doit être fourni par une compagnie de service désignée par Whirlpool.