Installation guide

ManualsBrandsWhirlpool ManualsWall oven/microwave comboOfficial Whirlpool 27" electric built-in oven/microwave combo

INSTALLATIONINSTRUCTIONS

27" (68.6 CM) AND 30" (76.2 CM) ELECTRICBUILT-IN

MICROWAVE/OVEN COMBINATION

INSTRUCTIONSD'INSTALLATIONDEL'ENSEMBLEFOURA

MICRO-ONDES ETFOURCONVENTIONNEL

e= e=

ELECTRIQUESENCASTRESDE 27" (68,6 CM) ET

30" (76,2 CM)

Table of Contents/Table des mati_res

BUILT-IN MICROWAVE/OVEN COMBINATION SAFETY ...................... 1

INSTALLATION REQUIREMENTS ........................................................... 2

Tools and Parts ....................................................................................... 2

Built-In Microwave/Oven Combination Location Requirements ........... 2

Electrical Requirements .......................................................................... 3

INSTALLATION INSTRUCTIONS ............................................................. 4

Prepare Built-In Microwave/Oven Combination .................................... 4

Remove Oven Door ................................................................................ 4

Remove Oven Trim ................................................................................. 4

Make Electrical Connection .................................................................... 4

Install Oven ............................................................................................. 5

Complete Installation .............................................................................. 6

SI_CURITI_ DE L'ENSEMBLE FOUR .&

MICRO-ONDES ET FOUR CONVENTIONNEL ENCASTRI_S ................ 7

EXIGENCES D'INSTALLATION ................................................................ 7

Outillage et pieces .................................................................................. 7

Exigences d'emplacement de I'ensemble four &

micro-ondes et four conventionnel encastres ....................................... 7

Specifications electriques ....................................................................... 8

INSTRUCTIONS D'INSTALLATION ......................................................... 9

Preparation de I'ensemble four a micro-ondes et

four conventionnel encastres ................................................................. 9

D_pose de la porte du four ..................................................................... 9

D_pose de la garniture du four ............................................................... 9

Raccordement electrique ..................................................................... 10

Installation du four ................................................................................ 11

Achever I'installation ............................................................................. 12

BUILT-INMICROWAVE/OVEN COMBINATION SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow

instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can

happen if the instructions are not followed.

iMPORTANT:

Save for local electrical inspector's use.

iMPORTANT :

A, conserver pour consultation par I'inspecteur local des installations 61ectriques.

W10192051A

Summary of content (12 pages)

PAGE 1
INSTALLATIONINSTRUCTIONS 27" (68.6 CM) AND 30" (76.2 CM) ELECTRICBUILT-IN MICROWAVE/OVEN COMBINATION INSTRUCTIONSD'INSTALLATIONDE L'ENSEMBLE FOURA MICRO-ONDES ETFOUR CONVENTIONNEL e= e= ELECTRIQUESENCASTRESDE 27" (68,6 CM) ET 30" (76,2 CM) Table of Contents/Table BUILT-IN MICROWAVE/OVEN COMBINATION INSTALLATION REQUIREMENTS ........................................................... Tools and Parts .......................................................................................
PAGE 2
INSTALLATIONREQUIREMENTS Yoos @s,d s Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Product Dimensions 27" (68.6 cm) and 30" (76.
PAGE 3
Cabinet Dimensions If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. 27" (68.6 cm) and 30" (76.2 cm) Ovens _A_ Check with a qualified electrical installer if you are not sure the oven is properly grounded. This oven must be connected to a grounded metal, permanent wiring system.
PAGE 4
Ifthehousehasaluminum wiringfollowtheprocedure below: 1. Connect asection ofsolidcopper wiretothepigtail leads. 2. Connect thealuminum wiringtotheaddedsection of copperwireusingspecial connectors and/or tools designed andULlistedforjoiningcoppertoaluminum. Follow theelectrical connector manufacturer's recommended procedure. Aluminum/copper connection mustconform with localcodesandindustry accepted wiringpractices. INSTALLATIONINSTRUCTIONS 1.
PAGE 5
4. InstallaULlistedorCSAapproved conduit connector tothe junction box. 5. 6. Connect the green (or bare) ground wire (H) from the oven cable to the green (or bare) ground wire (in the junction box) using a UL listed wire connector. Install junction box cover. 3-Wire Cable from A. UL listed or CSA approved conduit connector 5. 6. 7. Connection A B G Options Chart If your home has: Go to section: 4-wire 4-wire Cable from Home Power Supply - U.S.
PAGE 6
2. Push against seal area of front frame to push oven completely into cabinet and center oven into cabinet cutout. \ 3. 4. 5. On models with shipping feet, use a Phillips screwdriver to remove screws attaching the shipping feet. Push oven completely into cabinet and center oven into cabinet cutout. Securely fasten oven to cabinet using the # 8-14 x 1" screws (2 for single oven, 4 for double oven) provided. Insert the screws through holes in mounting rails. Do not overtighten screws.
PAGE 7
4. 5. Press START. Microwave oven should begin cooking, and the microwave oven interior light should be on. Let microwave oven complete cooking time. A tone will sound 4 times at the end of the cooking time, and the microwave oven will shut off. Open microwave oven door and slowly remove container. Water in container should be hot.
PAGE 8
Dimensions Vue lat_rale du placard du produit Fours de 27" (68,6 cm) et 30" (76,2 cm) D _C A. Profondeur de I'ouverture 23¼" (59,1 cm) min. B. Profondeur du four encastr_ 23" (58,4 cm) C. Fagade du four D. Four encastr_ E. Placard D ModUles de 27" (68,6 cm) A. Laraeur de I'encastrement 25 ¾_"_'/" (64,3 cm) B. Hauteur hors-tout 42_" (107,6 cm) C. Largeur hors-tout 26374'' (67,9 cm) D. Profondeur de I'encastrement 23" (58,4 cm) max. E.
PAGE 9
Un modele de 7,3 & 9,6 kW/240 volts (5,5 a 7,2 kW/208 volts) doit _tre alimente par un circuit independant de 40 A. Un modele de 7,2 kW ou moins a 240 volts (5,4 kW ou moins 208 volts) doit _tre alimente par un circuit independant de 30A. On recommande • L'installateur doit fournir un connecteur de conduit (homologation UL ou CSA).
PAGE 10
Tableau des options de raccordement C&blage de la maison : _lectrique Voir la section : 4 conducteurs C&ble & 4 conducteurs le point de distribution domicile depuis du 3 conducteurs C&ble & 3 conducteurs le point de distribution domicile depuis du Risque de choc _lectrique D_connecter I'entretien. la source de courant _lectrique avant Utiliser du fil en cuivre rigide de calibre 8. Relier le four a la terre.
PAGE 11
C&ble _ 3 conducteurs depuis le point de distribution domicile - I_.-U. seulement 2, Pousser contre la zone du joint du ch£ssis avant pour introduire completement le four dans le placard et centrer le four dans I'ouverture. 3. Sur les modeles avec pieds installes pour I'expedition, utiliser un tournevis Phillips pour 6ter les vis fixant les pieds installes pour I'expedition. Pousser completement le four dans le placard; centrer le four dans la cavite du placard.
PAGE 12
7. Faire glisser I'extremit6 superieure de chaque tringle de garniture, vers le haut, dans les rails lateraux du four. 9. 10. Reinstaller les grilles du four. 11. Reinstaller la porte du four - inserer les extremit6s des charnieres dans les ouvertures destinees ales recevoir, sur le chassis du four. F................ iF Utiliser les vis &t_te plate n° 8-18 x 3/8"fournies dans le sachet de vis, pour fixer chaque piece de garniture sur le four. ............... 12.