Before you start... Proper installation is the insmlleis responsibility. A qualified teclmiclsn should install this range. Make sure you have everythhg necesssIy for correct installation. It is the responsibility of tbe lr!stier to comply with the installation clearances specified on the serlalfrating plate. The sewrating plate is located under the cooktop.
E IF CONNECTING TO A 4-WIFtE . ELECTRICAL SYSTEM: This appliance is msnufactured with ground connected to cabinet. The ground must be revised so the green grounding wire of the I-wire power cord is connected to the osbklet. See 4-w&e elect&al connection section, Panel c. When a I-wire receptaole of NEMA type 14-60Ris used (See Figure 2) a matching U.L.- listed, I-wire, 250~volt, IO-ampere. range power supply cord (pigtall) must be used.
Range must be secured when mobile home is moved and at all times in a RV. recreational vehicle using the method descrlhed. Pull bottom of front Dane1out end lift UD to remove panel. Removing levehng legs. 16 Secure be range using 6/16” bolts, washers and nuts through the leveling leg holes. Replace lower access panel. Skip step 17.
If range does not operate... For cleaning and maintenance... If you need assistance... . Check that the circuit breaker is not tripped or the fuse blown. mCheck that power supply cord is plugged into wall receptacle. If removing the range is necessary for deerhgandmaintenan0e,disconnect elecmd SuPplY. If ekctdcal supply is inaccessible, lift the range slightly at the front and pull the range away from the wall. Pun tb13range outonlyasfsras neoessaIytodisoomlect the eleohic supply line. $zz.