Setup and user guide

ManualsBrandsWhirlpool ManualsDishwashersRSFO 3T224

Before using the appliance carefully read Health and Safety guide.

APPLIANCE

PRODUCT DESCRIPTION

1. Upper rack

2. Foldable  aps

3. Upper rack height adjuster

4. Upper spray arm

5. Lower rack

6. Space Zone

7. Cutlery basket

8. Lower spray arm

9. Filter Assembly

10. Salt reservoir

11. Detergent and Rinse Aid dispensers

12. Rating plate

13. Control panel

0000 000 00000

Service:

1112

96578 1210 1 1 13

1. On-O / Reset button with indicator light

2. Program selection button with indicator light

3. Half Load button with indicator light / Tablet (Tab)

4. Eco program indicator light

5. Display

6. Program number and remaining time indicator

7. Tablet (Tab) indicator light

DAILY REFERENCE

GUIDE

CONTROL PANEL

8. Closed water tap indicator light

9. Rinse Aid re ll indicator light

10. Salt re ll indicator light

11. Push & Go button with indicator light

12. Delay button with indicator light

13. Start/Pause button with indicator light / Drain out

You can download the Safety Instructions and the Use and Care Guide, by visiting our website

docs.whirlpool.eu and following the Instructions on the back of this booklet.

Summary of content (8 pages)

PAGE 1
EN DAILY REFERENCE GUIDE You can download the Safety Instructions and the Use and Care Guide, by visiting our website docs.whirlpool.eu and following the Instructions on the back of this booklet. Before using the appliance carefully read Health and Safety guide. PRODUCT DESCRIPTION APPLIANCE 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
PAGE 2
FIRST TIME USE SALT, RINSE AID AND DETERGENT ADVICE REGARDING THE FIRST TIME USE FILLING THE RINSE AID DISPENSER After installation, remove the stoppers from the racks and the retaining elastic elements from the upper rack. Rinse aid makes dish DRYING easier. The rinse aid dispenser A should be filled when the RINSE AID REFILL indicator light in the control panel is lit.
PAGE 3
EN Drying phase PROGRAMS TABLE Program 1 Eco Available options *) Detergent container Duration of wash program (h:min)**) Water consumption (litres/cycle) Energy consumption (kWh/cycle) 4:00 9.0 0.74 2:20 - 3:00 16.0 - 18.0 1.20 - 1.40 2:10 - 2:50 14.5 - 16.0 1.05 - 1.25 - 1:40 12.0 1.00 - 0:30 9.0 0.50 - 3:35 16.5 1.00 - 1:30 12.0 1.20 - 0:10 4.5 0.01 1:20 10.0 1.
PAGE 4
OPTIONS AND FUNCTIONS OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED flashes rapidly 3 times and beeps will sound. The option will not be enabled. HALF LOAD using the upper or lower rack DRAIN OUT If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and detergent.
PAGE 5
EN LOADING THE RACKS UPPER RACK LOWER RACK Load delicate and light dishes: glasses, cups, saucers, low salad bowls. For pots, lids, plates, salad bowls, cutlery etc... Large plates and lids should ideally be placed at the sides to avoid interferences with the spray arm. The upper rack has tip-up supports which can be used in a vertical position when arranging tea/ dessert saucers or in a lower position to load bowls and food containers.
PAGE 6
DAILY USE 1. CHECK WATER CONNECTION Check that the dishwasher is connected to the water supply and that the tap is open. 2. SWITCH ON THE DISHWASHER Press the ON/OFF button. 3. LOAD THE RACKS (see LOADING THE RACKS). 4. FILLING THE DETERGENT DISPENSER (see PROGRAMS TABLE). 5. CHOOSE THE PROGRAM AND CUSTOMISE THE CYCLE Select the most appropriate program in accordance with the type of crockery and its soiling level (see PROGRAMS DESCRIPTION) by pressing the P button.
PAGE 7
EN CARE AND MAINTENANCE CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS Regularly clean the filter assembly so that the filters do not clog and that the waste water flows away correctly. The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water: to obtain the best washing results, you need to keep them clean. On occasions, food residue may become encrusted onto the spray arms and block the holes used to spray the water.
PAGE 8
TROUBLESHOOTING Your dishwasher may not work properly. Before contacting the Service Centre check if the problem can be solved by going through the following list. PROBLEMS POSSIBLE CAUSES SOLUTIONS The dishwasher won’t start or does not respond to commands. The appliance has not been plugged in properly. Insert the plug into the socket. Power outage. The dishwasher starts automatically when the power returns. The dishwasher door is not closed. Vigorously push the door until you hear the “click”.