Instruction for Use

AUTOMATIC ICE MAKER
Useful hints on the automatic ice maker
To turn the ice maker on/off, press the On/Off button .
If the freezer compartment door is open, make sure the inside
flap is not blocked as it serves as lock sensor that shuts off the
transfer of ice from the automatic ice maker into the bucket
installed in the door.
To remove and replace the ice bucket:
1.
Place four fingers in bucket base opening and rest thumb on
the release button.
2. Holding the base of the bucket with both hands, press the
release button and lift the bucket up and out. It is not
necessary to turn the ice maker control to the OFF position.
The ice maker will not produce ice without the bucket
installed in the door.
 Normal Ice Production
should produce approximately 7 to 9
batches of ice in a 24-hour period.
Ice bucket care:
1.
Empty the bucket. Use warm water to melt the ice if
necessary.
Never use anything sharp
to break up the ice in
the bucket. This can cause damage to the ice bucket and the
dispenser mechanism.
2.
Wash the ice bucket with a mild detergent, rinse well and dry
thoroughly.
Do not use harsh or abrasive cleaners or solvents.
NOTE
: Do not turn the ice maker on until it is connected to the
water supply.

It is normal for ice cubes to be stick together at the corners.
They can be separated easily.

The ice maker will not operate until the freezer compartment
is cold enough to make ice.
This can take overnight.

Good water quality is important for good ice quality. Water
softener chemicals such as salt can damage the ice maker and
lead to poor quality ice.
3gb33009.fm5 Page 43 Monday, March 4, 2002 4:51 PM