Instructions for Installation and Use Gas Hob Model S830G Model S840G
CONTENTS Introduction For Your Safety Know your Hob How to use your Hob Practical Advice Care and Cleaning Troubleshooting Installation Electrical Connection Characteristics of Burners and Nozzels Key Contacts 3 4 5 5 6 7 7 8-10 11 12 Back Cover Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance.
Introduction Your new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully. The hob is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.
For Your Safety When used properly your appliance is completely safe but as with any electrical product there are certain precautions that must be observed. PLEASE READ THE BELOW PRECAUTIONS BEFORE USING YOUR APPLIANCE. To maintain the efficiency and safety of this appliance, we recommend you do the following: - only call the Service Centres authorised by the manufacturer. - always use genuine spare parts. NEVER: - attempt to install or repair the appliance without the assistance of qualified personnel.
Know your Hob A F B D C A. B. C. D. E. Ignition Button for Gas Burners (only on certain models) F. Safety Device (only on certain models) - Activates if the flame accidentally goes out (spills, drafts, etc.), interrupting the delivery of gas to the burner. Gas Burners Support Grid for Cookware Control Knobs for Gas Burners Ignitor for Gas Burners (only on certain models) How To Use Your Hob The position of the corresponding gas burner is indicated on each control knob.
Practical Advice Practical Advise on Using the Burners For best performance, follow these general guidelines: • Use the appropriate cookware for each burner (see table) in order to prevent the flame from reaching the sides of the pot or pan; • Alwasy use cookware with a flat bottom and keep the lid on; • When the contents come to a boil, turn the knob to "Low".
Care and Cleaning Before cleaning or performing maintenance on your hob, disconnect it from the power supply. • To extend the life of the hob, it should be cleaned carefully and thoroughly on a frequent basis, keeping in mind the following: • The enamelled parts must be washed with warm water without using abrasive powders or corrosive substances which could ruin them. • The removable parts of the burners should be washed frequently with warm water and soap, making sure to remove caked-on substances.
Installation The following instructions are intended for the installer so that the installation and maintenance procedures may be followed in the most professional and expert manner possible. Important: Disconnect the appliance from the electrical supply before performing any maintenance or repair. d) Liquidified petroleum gases are heavier than air and, as a result, settle downwards.
Installation Gas Connection for the Hob The hob should be connected to the gas supply by an authorized installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing.
Installation Adapting the Hob for DifferentTypes of Gas To adapt the hob to a different type of gas than that for which it was designed, (see the sticker under the hob or on the packaging), the burner nozzles must be changed, as follows: • Remove the pan supports and slide the burners out of the cooktop. • Unscrew the nozzles using a 7mm socket wrench and replace them with those for the new type of gas. (See table 1, “Burner and Nozzle Specifications”).
Electrical Connection Before connecting to the power supply, make sure that: • the limiter switch and the domestic system can withstand the load from the appliance (see rating plate). • the supply system is efficiently earthed according to standards and laws in force. • the socket or double-pole switch are easily accessible Electrical connection WARNING: THIS APPLIANCE MUST BE EARTHED.
Characteristic of the burners and nozzles Table 1 Liquid Gas Burner Diameter (mm) Thermal power kW (p.c.s.*) By-Pass 1/100 Nozzle 1/100 Natural Gas Flow* g/h Nozzle 1/100 Nomin. Ridot.
Notes 13
Notes 14
Notes 15
Key Contacts After Sales Service Over 1200 trained specialists, directly employed by us, ensure that you can have complete confidence in both the appliances and services we offer. Repair Service and Information Desk UK: 08709 066 066 (Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays) www.theservicecentre.co.