Installation guide

2. Locate LP gas orifice spuds for top burners in the bag
containing literature included with the range. Three LP gas
spuds are stamped "78" and two are stamped "84."
3. Remove natural gas orifice spuds using a 7mm combination
wrench.
4. Install LP gas orifice spuds.
NOTE: Depending on model, the range cooktop may be
equipped with 4 standard burners, 3 standard burners and 1
power burner, or 3 standard burners, 1 power burner and one
center burner. Spud size/location remain the same.
5. Place the natural gas orifice spuds in the parts bag for future
To Convert Oven Burner
1. Open oven door and remove oven racks, oven tray, flame
spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner air
shutter.
3. Locate LP gas orifice spud stamped "56" in bag containing
literature supplied with range.
©
A. Air shutter
4. Use a 7 mm combination wrench and remove the natural gas
orifice spud.
A. Spud
B. Holder
A. LP oven orifice spud stamped with "56"
B. Oven Burner Air Shutter
IMPORTANT: Do not overtighten.
5. Install the number "56" LP gas spud.
6. Place natural gas oven burner spud in plastic parts bag along
with natural gas cooktop burner spuds for future use and
keep with the bag containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.
use and keep with the bag containing literature.
Reinstall burners, burner caps and burner grates.
1. Refer to the "Make Gas Connection" section for properly
connecting the range to the gas supply.
2. Turn the gas manual shutoff valve to the "open" position.
3. Refer to the "Check Operation" section for proper burner
ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame 1/4"to 1/2"(6.4 mm to 13 mm) long. The outer cone
is not as distinct as the inner cone. LP gas flames have a
slightly yellow tip.
4. Close the broiler door and press the "CANCEL/OFF" pad.
5. Refer to the "Complete Installation" section to complete this
procedure.
13