] AWARNING . ALL RANGES CAN TIP . INJURY TO PERSONS COULD RESULT . INSTALLANTI-TIP DEVICE PACKED WITH RANGE . SEEINSTALLATION INSTRUCTIONS Part No. 36-3 14445-02-O/4363404 IMPORTANT: Read and save these instructions. IMPORTANT: IIlStdkr: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use.
Before you start... Check location where range will be installed WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. - Do Not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. - WHAT TO DO IF YOU SMELLGAS l Do Not try to light any appliance. l Do Not touch any electrical switch; Do Not use any phone in your building.
Tools needed for installation: l l l l hand or electric drill concrete/ceramic floors: Q/16” masonry drill bit wood floors: 3/32” drill bit gas line shutoff valve L.P.-resistant pipe-joint compound A.G.A. design-certified flexible metal connector (A-5 feet) wrench V ‘V r I n The supply line shall be equipped with an approved shutoff valve. This valve should be located in the same room as the range and should be in a location that allows ease of opening and closing.
the line drawn. Note: If there is a cabinet on only one side, the anti-tip bracket must be installed against the cabinet, Now start... With range in kitchen. 1 2 Go to Step 7. w Remove inside oven. racks and other parts from 6 A n If range is Not installed against a cabinet, both anti-tip brackets must be installed. l Slide range into final location. Mark a line on the floor along sides of range about one-half the distance from the rear to the front. -;iI W Place one foot on the shipping base.
23 n Check the oven burner for proper flame. Open the oven door and remove the lower oven rack and oven bottom. Push in and turn oven selector knob to “BAKE”. Push in and turn oven control knob to 300°F. The oven burner should light in 50-60 seconds. This delay is normal. The oven safety valve requires a certain time before it will open and allow gas to flow. Numbers correspond to steps. Product Damage Do Not insert any object into the openings of the protective shield that surrounds the ignitor.
Natural gas conversion L.P. gas conversion Converting to L.P. gas should be done by a qualified installer. The ignitor must remain in its shield when 1 removing ba~~~~p.““’ Failure to do so could break ignitor. Fire Hazard . Locate gas supply valve between pressure regulator and gas valve. Shut off gas supply valve to range before converting to L.P. gas. Make all cooktop, oven and broil burner conversions before turning gas supply valve back on.
D Plug power supply cord into outlet. Make sure that rear leveling leg(s) are engaged in anti-tip bracket(s). H Replace storaae drawer, oven bottom, oven racks acd oven door. Reinstall maintop and burner grates, burner caps and burner bases. See Panel D, Step 22. Product Damage The ignitor must remain in its shield when removing bar broil burner. Failure to do so could break ignitor. If range does not operate...