Installation guide

ManualsBrandsWhirlpool ManualsRangeOfficial Whirlpool gas range

WARNING

• ALL RANGES CAN

TIP

• INJURY TO PERSONS

COULD RESULT

• INSTALL ANTI-TIP

DEVICE PACKED

WITH RANGE

• SEE INSTALLATION

INSTRUCTIONS

Quick Reference

Table of Contents:

Pages

[]

%-%

r Backcover1

I Back cover!

I Backcovar]

Before you start

Product dimensions

Cabinet dimensions/requirements

Electrical requirements

Gas supply requirements

Installation steps

Gas conversions

If range does not operate

If you need assistance/service

Moving the range

If you need assistance:

Check your Use and Care Guide for a toll-free number to call or call

the dealer from whom you purchased this range. The dealer is listed

in the Yellow Pages of your phone directory under "Appliances-

Household -- Major -- Service and Repair."

Call when you:

Have questions about range installation or operation.

[] Need to obtain the name and number of an authorized

servme company.

When you call, you will need:

[] The range model number.

[] The range serial number.

Both numbers are listed on the model/serial rating plate located on

the frame behind the storage drawer.

Summary of content (9 pages)

PAGE 1
Quick Reference Table of Contents: Pages Before you start [] [] [] [] %-% Product dimensions Cabinet dimensions/requirements Electrical requirements Gas supply requirements Installation steps Gas conversions r Back cover 1 If range does not operate I Back cover ! If you need assistance/service I Backcovar] Moving the range If you need assistance: WARNING • ALL RANGES CAN TIP • INJURY TO PERSONS COULD RESULT • INSTALL ANTI-TIP DEVICE PACKED WITH RANGE • SEE INSTALLATION INSTRUCTIONS Check your Use
PAGE 2
Important: Observe all governing codes and ordinances. This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 -- latest edition**. Proper installation is your responsibility. A qualified technician must install this range.
PAGE 3
level Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary•In addition to checking that the outlet is correctly grounded, the outlet must be checked by a qualified electrician to see if it is wired with correct polarity. _._1 1/8" drive " _ _q ratchet Iflat.
PAGE 4
Check cooktop burners for proper flame Plug power supply cord into grounded outlet Check broiler burner for proper flame i Make proper gas connection Chock oven burner for proper flame Install anti, tip bracket Secure range with anti-tip bracket ! Level range Replace storage drawer Preparation = Put on safety glasses and gloves, Do Not use oven door handle to lift or move the range, Injury Hazard Because of the weight and size of this range, two or more people are required to move it.
PAGE 5
Operating position Before moving range across floor, checkthat range is still on cardboard shipping base to protect floor covering. front levelingleg = Carefully move range into final operating position. Check that rear leveling leg is engaged in anti-tip bracket. rear leveling leg Place rack in oven, Place level on rack, first side to side; then front to back. = Remove cardboard shipping base from under range. Remove storage drawer. Use a 3/8" drive ratchet to lower rear leveling legs one-half turn.
PAGE 6
Check operation mirror Electronic ignition system Cooktop and oven burners use electronic ignitors in place of standing pilots. When a cooktop control knob is turned to the "LIGHT" position, the system creates a spark to light the burner. This sparking continues until the control knob is turned to the desired setting. When the oven control is turned to the desired setting, a hot surface ignitor heats up bright orange and ignites the gas.
PAGE 7
Check operation (cont.) =_:I:1 = C.LO_ g_,lcE _ START _ -- CLE_N _0 • ooo_ I / ON I O J m and screw A 1. Press the "CUSTOM BROIL" pad. • "HI" will appear in the display. • The "BROIL" indicator will light. • The "START?" indicator will begin to flash after 5 seconds. B 1. Press the "CUSTOM BROIL" pad. • "525" or "HI" will appear in the display. • The "BROIL" indicator will light. • The "START?" indicator will begin to flash after 5 seconds. 2. Press the "START/ENTER" pad.
PAGE 8
= Natural gas conversion Cooktop burners: Pull range out from countertop front about 4 inches. There are two clips, one on each side, located underneath the cooktop 2-3/8 inches back from the front of range. Carefully slide a putty knife in between the cool(top and the oven part of range. While gently lifting the cooktop, push in on the putty knife to release the clip. Repeat on other side. • Complete installation sectionsA-C (Pages 3-4) before converting cooktop to natural gas.
PAGE 9
If rangedoes not operate: Moving the range: [] Check that the circuit breaker is not tripped or the house fuse blown. [] Check that the power supply cord is plugged into the wall receptacle. Check that gas line is turned on. See Use and Care Guide for troubleshooting list. [] [] When moving range, slide range onto cardboard or hardboard to prevent damaging the floor covering.