TM TWO-SPEED AUTOMATIC WASHER Use & Care Guide Table of Contents ......................................
TABLE OF CONTENTS WASHER SAFETY ............................................................ 3 PARTS AND FEATURES .................................................... 4 USING YOUR WASHER...................................................... 5 Understanding Washer Cycles........................................ 5 Loading ............................................................................. 5 Normal Washer Sounds................................................... 5 Starting Your Washer.................
WASHER SAFETY Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you and others. All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING.” These words mean: DANGER You will be killed or seriously injured if you don't follow instructions.
PARTS AND FEATURES 1. Control panel 5. Lid 2. Model and serial number label 6. Liquid bleach dispenser 3. Liquid fabric softener dispenser 7. Basket 4. Agitator 8.
USING YOUR WASHER Understanding Washer Cycles When the Cycle Control knob is set to a number and pulled out, the washer fills (to the selected load size) before agitation and timing start. The washer begins agitating immediately after filling; agitation occurs with the washer lid up or down. During agitation, the agitator (on some models) creates a continuous rollover action that provides a thorough cleaning of the wash load.
1. Measure detergent and pour it into the washer. Starting Your Washer Fire Hazard ■ If desired, add powdered or liquid color safe bleach. ■ Add extra detergent for the Super Wash cycle. 2. Drop a sorted load of clothes loosely into your washer. Never place items in the washer that are dampened with gasoline or other flammable fluids. No washer can completely remove oil. Do not dry anything that has ever had any type of oil on it (including cooking oils).
4. (OPTIONAL STEP) Pour measured liquid fabric softener into the liquid fabric softener dispenser. Softener is added automatically during the rinse portion of the cycle. 7. Set the TEMPERATURE selector to the correct setting for the type of fabric and soils being washed. ■ Use the warmest water safe for fabric. ■ Follow garment label instructions.
Selecting a Cycle and Time This section describes the available wash cycles and will help you make the best cycle selections for your wash loads. Each cycle is designed for different types of fabric and soil levels. ■ ■ The washer pauses briefly throughout each cycle. These pauses are normal. Refer to “Normal washer sounds” to learn more about the sounds you may hear during a wash cycle. Refer to “Understanding washer cycles” to learn what happens during a wash cycle.
CARING FOR YOUR WASHER Water Inlet Hoses Replace inlet hoses after five years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker. Cleaning Your Washer Vacation, Storage, and Moving Care Cleaning the exterior Use a soft, damp cloth or sponge to wipe up any spills such as detergent or bleach.
TROUBLESHOOTING Washer won’t drain or spin ■ Is the drain hose clogged, or the end of the drain hose more than 72 inches (183 cm) above the floor? See the Installation Instructions for proper installation of drain hose. ■ Is the lid open? The lid must be closed during operation. ■ Is there excessive sudsing? Always measure detergent. Follow manufacturer’s directions. If you have very soft water, you might need to use less detergent. ■ Is your voltage low? Check electrical source or call electrician.
Washer leaks ■ Check the following: Are the fill hoses tight? Are the fill hose washers properly seated? Is the drain hose clamp properly installed? See the Installation Instructions. ■ Is the sink or drain clogged? Sink and standpipe must be able to handle 17 gallons (64 L) of water per minute. ■ Is water deflecting off the tub ring or the load? Center the tub before starting the washer. The wash load should be balanced and not overloaded. The fill or spray rinses can deflect off the load.
Load is wrinkled ■ Did you unload the washer promptly? Unload the washer as soon as it stops. ■ Did you use the right cycle for the load being washed? Use the Permanent Press cycle or another cycle with low spin speeds (if available) to reduce wrinkling. ■ ■ ■ Did you overload the machine? The wash load must be balanced and not overloaded. Loads should move freely during washing.
For further assistance ASSISTANCE OR SERVICE Before calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you still need help, call the Whirlpool Consumer Assistance Center toll free at 1-800-253-1301. When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond to your request.
NOTES 14
NOTES 15
WASHER WARRANTY TM TWO-YEAR FULL WARRANTY For two years from the date of purchase, when this washer is operated and maintained according to instructions attached to or furnished with the product, Whirlpool will pay for Factory Specified Parts and repair labor to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company.
