SIUF 32121 ULTIMA GB English Operating instructions DISHWASHER - Contents Operating instructions,1 Precautions and advice, 2-3 Product Data, 3 Installation, 4-5 Description of the appliance, 6 Refined salt and rinse aid, 7 Loading the racks, 8-9 Detergent and dishwasher use, 10 Wash cycles, 11 Special wash cycles and options, 12 Care and maintenance, 13 Troubleshooting, 14 After-Sales Service, 15 Guarantee, 16
GB Precautions and advice This appliance was designed and manufactured in compliance with international safety standards. The following information has been provided for safety reasons and should be read carefully. Keep this instruction manual in a safe place for future reference. If the appliance is sold, given away or moved, make sure the manual is kept with the machine. Read the instructions carefully, as they include important information on safe installation, use and maintenance.
odours with the Soak cycle Wash Cycles). (if available, see • Select a wash cycle that is suited to the type of crockery and to the soil level using the Table of Wash Cycles: - For dishes with a normal soil level, use the Eco wash cycle, which guarantees low energy and water consumption levels. - If the load is smaller than usual activate the Half Load option (see Special wash cycles and options, if available).
Installation GB If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it may be tilted onto its back. Positioning and levelling 1. Position the dishwasher on a level sturdy floor. If the floor is uneven, the front feet of the appliance may be adjusted until it reaches a horizontal position. If the appliance is levelled correctly, it will be more stable and much less likely to move or cause vibrations and noise while it is operating. 2.
If the power supply cable is damaged, have it replaced by the manufacturer or its authorised Technical Assistance Service in order to prevent all potential hazards. (See Assistance) The Company shall not be held responsible for any incidents, if these regulations are not observed. This appliance must be earthed. Fuses:your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only those rated at 13A and ASTA approved to BS1362 should be used.
Description of the appliance GB Overall view 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12.
Refined Salt and Rinse Aid Only use products which have been specifically designed for dishwashers. Do not use table salt or industrial salt. Follow the instructions given on the packaging. If you are using a multi-function product, we recommend that you add salt in any case, especially if the water is hard or very hard. (Follow the instructions given on the packaging.) If you do not add salt or rinse aid, the LOW SALT* and LOW RINSE AID* indicator lights will remain lit.
Loading the racks GB Tips Before loading the racks, remove all food residues from the crockery and empty liquids from glasses and containers. No preventive rinsing is needed under running water. Arrange the crockery so that it is held in place firmly and does not tip over; and arrange the containers with the openings facing downwards and the concave/convex parts placed obliquely, thus allowing the water to reach every surface and flow freely.
Tray* Some dishwasher models are fitted with a sliding tray which can be used to hold small crockery and cutlery. For optimum washing performance, avoid positioning bulky crockery directly below the tray. The cutlery tray can be removed. (see Figure.) Adjusting the height of the upper rack The height of the upper rack can be adjusted: high position to place bulky crockery in the lower rack and low position to make the most of the tip-up compartments by creating more space upwards.
Detergent and dishwasher use GB Measuring out the detergent Good washing results also depend on the correct amount of detergent being used. Exceeding the stated amount does not result in a more effective wash and increases environmental pollution. The amount can be adjusted to the soil level. In the case of normally soiled items, use approximately either 25g (powder detergent) or 25ml (liquid detergent). If tablets are used, one tablet will be enough.
Wash cycles Wash-cycle data is measured under laboratory conditions according to European Standard EN 50242. Based on the different conditions of use, the wash-cycle duration and data can change. GB The number and type of wash cycles and options may vary depending on the dishwasher model. Wash cycle which include drying Options Approximate duration of wash cycles h:min. Water consumption (l/cycle) Energy consumption (KWh/cycle) 1. Eco Yes Delayed start – Half Load - Tabs 03:00 9,0 0,74 2.
Special wash cycles and Options GB Notes: Optimum performance levels when using the “Express” cycles can be achieved by respecting the specified number of place settings. To reduce consumption even further, only run the dishwasher when it is full. Note for Test Laboratories: for information on comparative EN testing conditions, please send an email to the following address: assistenza_en_lvs@indesitcompany.
Care and maintenance Shutting off the water and electricity supplies • Turn off the water tap after every wash cycle to avoid leaks. • Always unplug the appliance when cleaning it and when performing maintenance work. Cleaning the dishwasher • The external surfaces of the machine and the control panel can be cleaned using a non-abrasive cloth which has been dampened with water. Do not use solvents or abrasive products.
Troubleshooting GB Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance. Problem: Possible causes / Solutions: The dishwasher does not start • The water supply tap is not turned on. or cannot be controlled. • Switch off the appliance by pressing the ON/OFF button, switch it back on after approximately one minute and reset the wash cycle. • The appliance has not been plugged in properly or another electricity socket should be used.
After Sales Service After Sales Service Appliance Registration No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. We want to give you additional benefits of Hotpoint ownership. To activate your free 5 year parts guarantee you must register your appliance with us.
Guarantee 195124383.00 - NC 04/2014 jk - Xerox Fabriano Guarantee GB 12 months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you.