Instruction for Use

Pipe direction

trough

Note: When installing the pipe at the directions

1,2 or 4, saw the corresponding unloading piece

off the indoor unit base.

Unloading

piece

Saw the unloading piece

off along the trough

Put the pipes (liquid and gas pipe) and cables through the wall hole from outside or put them through

from inside after indoor pipe and cables connection complete so as to connect to outdoor unit.

Decide whether saw the unloading piece off in accordance with the pipe direction.(as shown below)

3. Indoor Unit Pipe Installation

Installation instructions

Indoor

Outdoor

Wall hole sleeve

( hard polythene tube

prepared by user)

5mm

(tilt downward)

Install a sleeve through the wall hole to keep the wall

tidy and clean.

Drill a hole on the wall about 50mm. The hole should

tilt a littledownward toward outside.

Decide the position of hole for pipe according to the

location of mounting plate.

2. Drill a Hole for Pipe

.Keep the mounting plate horizontally with a horizontal ruler or level.

Drill holes of 32mm in depth on the wall for fixing the plate.

Insert the plastic plugs to the hole, fix the mounting plate with tapping screws.

Inspect if the mounting plate is well fixed. Then drill a hole for pipe.

1. Installing the Mounting Plate

Decide an installing location for the mounting plate according to the indoor unit location and pipe direction.

Indoor unit installation

After connecting pipe as required, install the drain hose. Then connect the power cords. After connecting,

wrap the pipes, cords and drain hose together with thermal insulation materials.

Mounting plate

Tapping screw

Note: The shape of your mounting plate may be different from the one above, but the installation method is similar.

Note: As the above figure shown, the six holes matched with tapping screw on the mounting plate must be used to

fix the mounting plate, the others are prepared.