A WARNING . ALL RANGES CAN TIP . INJURY TO PERSONS COULD RESULT . INSTALLANTI-TIP DEVICE PACKED WITH RANGE . SEEINSTALLATION INSTRUCTIONS -307563-02-O/4363 123 IMPORTANT: Read and save these instructions. Important: Installer: Leave Installation instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use.
Before you start... Check location where range will be installed. The location should be away from strong draft areas, such as windows, doors, and strong heating vents or fans, The range should be located for convenient use in the kitchen. Recessed installations must provide complete enclosure of the sides and rear of range. Proper installation is your responsibility. A qualified technician should install this range. Make sure you have everything necessary for correct installation.
C This range is equipped for use with NATURAL gas only and is designcertified by A.G.A. n Electrical requirements Ductwork needed is not included. D n Provide a gas supply line of 3/4” rigid pipe to the range location. A smaller size pipe on long runs may result in insufficient gas supply. Pipejoint compounds made for use with NATURAL and L.P. gas must be used. E n If local codes permit, A.G.A. design-certified flexible metal tubing is recommended for connecting this range to the gas supply line.
Floor venting installation Recommended Now start... standard fittings connects to range exhaust + With range in kitchen. floor duct 1. Q- Remove racks and other parts from inside oven. Remove venting kit from storage drawer and remove elbow taped to cardboard base behind storage drawer. wall/floor transition 3-l/4” x 10” 900 elbow= =5R. I 3-l/4” x 10” wall cap=Oft. 3-l/4” x 10” flat elbow = 12 ft.
10. Use a pencil to mark the two mounting screw hole locations on the anti-tip bracket. Remove bracket from position. Fire Hazard Do Not make connection too tight. The regulator is die cast. Overtightening may crack the regulator, resulting in a gas leak and possible fire or explosion. shim Floor Damage With backsplash Without backsplash For countertops with a backsplash, the distance from the rear wall to the gasket must be at least 2-l /2”; 2-5/8” maximum. All connections tightened.
Numbers correspond to steps. Product Damage Do Not insert any object into the openings of the protective shield that surrounds the ignitor. Do Not clean the area. Failure to follow these instructions could result in product damage. 29. 24. 27 n Check the oven burner for proper flame. The flame should be l/2” long, with inner cone of bluish-green, an outer mantle of dark blue and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur.
If you need setice... If range does not operate... maintenance... In the event that your Whirlpool appliance should need service, call the dealer from whom you purchased the appliance or a Whirlpoolauthorized service company. A Whirlpool-authorized service company is listed in the Yellow Pages of your telephone directory under “Appliances Household - Major - Service or Repair”.