Setup and user guide

EN
Quick guide
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT
In order to receive a more complete assistance, please
register your product on www . whirlpool . eu/ register
Before using the appliance carefully read the Safety
Instruction.
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting the
appliance to the power supply.
Connect the appliance to the power supply and turn the thermostat
knob to switch on the appliance.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available).
CONTROL PANEL
1. On/standby
2. Temperature display
3. Fast cool button
4. Alarm indicator
5. Temperature button
6. 6th sense fresh control
4.
5.
1.
3.2.6.
ON/STANDBY
To put the product in Stand-by, press and hold the button
for 3
seconds. All the icons turn o except On/Standby indicator
. To
reactivate the appliance press once (briey) this button. (seethe
Instructions for Use)
FAST COOL BUTTON
Using Fast Cool function it is possible to increase the cooling
capacity in the refrigerator compartment. The use of this function
is recommended when placing a very high quantity of food in the
refrigerator compartment. Press the Fast Cool button
to activate
Fast Cool function. When activated, the Fast Cool indicator turns on.
The function is automatically disabled after 6 hours, or can be manually
disabled by pressing Fast Cool button
again.
STOP ALARM BUTTON
Press in case of alarm to mute the acoustic alarm.
TEMPERATURE BUTTON
Press the temperature button
to change the temperature: thevalue
changes cyclically between 8°C ad 2°C.
Note: Displayed set points correspond to the average temperature
throughout the whole refrigerator.
6TH SENSE FRESH CONTROL
This function automatically works to ensure the optimal conditions to
preserve the stored food. To deactivate the “6thSense Fresh Control”,
press and hold Fast Cool
and Stop Alarm buttons at the same
time for 3seconds until an audible signal sounds and “6th Sense Fresh
Control” icon
turns o as conrmation that the feature has been
deactivated. To reactivate this function repeat the same procedure.
Note: Deactivation of the function switch-o the FAN in the fridge.
FAN
The Fan improves temperature distribution inside the product,
allowing better preservation of stored food. By default, the fan is
switched on. To switch o the FAN press and hold Fast Cool
and
Stop alarm
buttons at the same time for 3 seconds until an audible
signal sounds and “6
th
Sense Fresh Control” icon will turn o as
conrmation that the fan has been switched o. To switch on the FAN
repeat the same procedure. As a conrmation audible signal sounds
and the icon turns on.
Note: Reasons why switch o the fan look for “ENERGY-SAVING TIPS” in the
Instructions for Use.
VACATION BUTTON
This function can be activated to reduce the energy consumption of
the appliance during a prolonged period of time.
Before activating the feature, all perishable food should be removed
from the refrigeration compartment and make sure that the door
is closed properly, since the refrigerator will maintain asuitable
temperature to prevent the formation of unpleasant odors (+12°C). To
activate/ deactivate press the Vacation mode button for 3 seconds.
When the function is enabled, the related symbol will light up
and the temperature of the refrigerator compartment will be set
to a higher setpoint (thetemperature display will show the new
temperature setpoint of +12°C). Changing the temperature setpoint
will automatically deactivate the function.