Operating instructions

Porcher, 6615 West Boston Street, Chandler, AZ 85226 9
STEP 4. Carefully remove construction debris from bath. Clean surfaces using soft cloth with warm
water. Water-test the bath and check for leaks.
INSTALLING ELECTRICAL
All wiring must be performed by a licensed electrician in accordance with all local codes and the national
electrical code.
WARNING- When using electrical products, basic precautions should always be observed. Always
disconnect the bath before servicing. Ensure installation is to permit access for service.
Whirlpool Electrical Note
The power supply shall be a 120 vac, 60 hz gfci (ground-fault circuit interrupter) protected receptacle on a
dedicated circuit. The wires shall be sized for a minimum circuit ampacity of 19.5 amps and protected by
a 20 amp maximum gfci.
Heater Electrical Note
The power supply shall be a 120 vac, 60 hz gfci (ground-fault circuit interrupter) protected receptacle on a
dedicated circuit. The wires shall be sized for a minimum circuit ampacity of 15 amps and protected by a
15 amp maximum gfci.
CARE AND MAINTENANCE
YOUR PORCHER WHIRLPOOL BATH IS DESIGNED TO LAST INDEFINITELY WITH
REASONABLE CARE AND MAINTANCE
GENERAL CLEANING
The high-gloss acrylic surface is resistant to impact and retains its luster with proper care and
maintenance. An integral, slip-resistant surface is incorporated for user safety. It bath mats are employed,
they must be removed after each use. Do not use harsh abrasives or caustic cleaners to clean fixture
surfaces. A mild detergent, warm water, and a soft cloth will remove normal dirt and soap accumulations
from fittings and surfaces. Rinse thoroughly after cleaning and polish with a soft dry cloth to restore
original luster of material.
DRAIN CLEANERS
Caustic drain cleaners can damage the acrylic surface if allowed to stand in bath. Clean acrylic surface
thoroughly after each use.
Caution: Do not permit drain cleaner to enter the circulation system.
CIRCULATION SYSTEM CLEANING-PURGING PROCEDURES
STEP 1. Once every three months purge and clean the circulating system. Fill whirlpool with warm water
and add two teaspoons of dishwasher detergent and one-half cup of household bleach