Operating instructions

18
Operation and Functions for Pool Control
Whirlpool Series 300
Exafill
The innovative drain system Exafill supersedes the usual
draining method by integrating three functions in one:
Exafill is bath inflow, bath drain and bath overflow all in
one!
Attention! According to the DVGW (German Association
of Gas and Water Specialists) standard, an on-site pipe
interrupter must be available when the Exafill is connected.
Check water circuits according to local regulations.
The bath inlet function is sealed off at the factory when the
bath rim option is not fitted.
Air system
Air (on/off) (button 1, Fig. 1)
The air blower is switched on or off with this button.
When the light by the on/off button is lit, the blower is
running. The system is switched off when the button is
pressed again.
Air (+) (button 2, Fig. 1)
The air blower speed and therefore the air volume in the
bath is increased by pressing and holding this button.
Touching the button for a short time increases the air
volume in steps.
Air (-) (button 3, Fig. 1)
The air blower speed and therefore the air volume in the
bath is decreased by pressing and holding this button.
Touching the button for a short time decreases the air
volume in steps.
Interval function and blower run-on
Pressing the (+) and (-) buttons (buttons 2 and 3) at the
same time activates the interval function. Various water
waves are created. An electronic control switches the
blower from lowest to highest speed every 10 seconds.
The interval function can be switched off again by
pressing the on/off button.
The air system also includes a blower run-on function.
When the bath is empty, the blower runs on and serves
to drain possible residual water under the nozzles. This is
performed approx. 10 minutes after switching the system
off with the on/off button (button 1, Fig. 1). The blower
run-out is active for approx. 10 seconds. The system
switches off automatically afterwards.
Whirlpool 300 Operation
• Hydro pulsation (button 5) only on
Whirlpool Series 700.
• Hydro cleaning (button 6) optional on
Whirlpool Series 300 and 700.
Fig. 1
Ideally located air and massage nozzles ensure a bubbling
bathing pleasure. The pressure of all massage nozzles are
identical on the air/hydro whirlpool system. An air controller
at the bath rim (air control) serves to feed air to control the
intensity of the water jets and thereby ensure a pleasant, direct
massage.
Scope of delivery of Series 300 Whirlpools
– Air nozzles with interval function and blower run-on
– Adjustable water nozzles with separate air control
(Air control)
– Electronic control element (Pool control)
– Exafill