Operating instructions

22
Options for Whirlpool Series 300/700:
• Underwater lighting
• Hydro bath heating 1.5 kW (3 kW for
Whirlpool Series 780/790)
• Hydro cleaning
• Bath rim thermostat (bath rim thermostat, hand shower,
Exafill, shut-off and switch-over)
• Grabrails
Underwater lighting
The underwater halogen lamp in attractive design creates a
very special bathing atmosphere. The 12V underwater lighting
is automatically controlled by a water level sensor. The lamp
is automatically switched on when the specified water level is
reached and switched off when the water is below this level.
When the lighting is defective, loosen the chrome ring and
replace the bulb.
Hydro bath heating
The water in the bath cools down slowly due to the good
insulation of sanitary acrylic material and retains its optimum
temperature with the Hydro bath heating. The Hydro heating
system is automatically switched on (initiated by pressure
control and sensor) with an adequate water level and the
Hydro pump activated. This control ensures that the heating is
not switched on when the water level is too low. The heating
element is thermally protected. A temperature of 40 °C is
pre-set. The heating rating is 1.5 kW or 3 kW on models
780 and 790.
Options
Underwater lighting
bath heatert