Specifications
If You Need Assistance
Or Service
This section is designed to help you save the cost of a service call. Part 1 of this section
outlines possible problems, their causes, and actions you can take to solve each problem.
Parts 2 and 3 tell you what to do if you still need assistance or service. When calling our
Consumer Assistance Center for help or calling for service, please provide a detailed descrip-
tion of the problem, your appliance’s complete model and serial numbers and the purchase
date. (See page 2.) This information will help us respond properly to your request.
1. Before calling for assistance . . .
Performance problems often result from little things you can find and fix without tools of any
kind. Please check the chart below for problems you can fix. It could save you the cost of a
service call.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Nothing will
The power cord is not plugged
Plug the power cord into a live circuit
operate
into a live circuit with proper
with proper vottage. (See Installation
voltage.
Instructions.)
A household fuse has blown or
Replace household fuse or reset circuit
a circuit breaker has tripped.
breaker.
The oven will
You have not turned the Oven
Turn the Oven Selector to the desired
not operate
Selector to BAKE or BROIL.
setting.
You have set a delayed start
Wait for the start time to be reached.
time.
You have not turned the Oven
Turn the Oven Temperature Control
Temperature Control Knob to a
Knob to a temperature setting.
temperature setting.
You have not set the
MEALTIMER” clock correctly.
Set the MEALTIMER clock correctly.
(See “Using the MEALTIMER clock” on
page 16.)
You have not set the
If a delay start or stop is not desired, the
MEALTIMER clock’s Stop or
Stop and Start Time Knobs must be
Start Time Knobs at the correct
turned to the correct time of day. Turn
time of day.
knobs till they pop out.
The surface
A household fuse has blown or Replace household fuse or reset circuit
units will not
a circuit breaker has tripped. breaker.
operate
You have not plugged in
Turn control knobs to OFF and plug
surface units all the way. surface units in all the way. (See
“Replacing” on page 24.)
You are not setting the control Push control knobs in before turning to a
knobs correctly. setting.
Control
You are not pushing in before Push control knob(s) in before turning to
knob(s) will
turning.
a setting.
not turn
continued on next page
29