4gb61591.
4gb61591.fm5 Page 14 Wednesday, May 29, 2002 2:19 PM Before using the cooktop These instructions are only valid for those Countries where the destination abbreviations are mentioned on the rear cover of the user instructions and on the appliance. To get full satisfaction of your cooktop, please read these instructions carefully and keep them for future consultation. Keep the packaging material (plastic bags, polystyrene parts, etc.
4gb61591.fm5 Page 15 Wednesday, May 29, 2002 2:19 PM Energy saving tips The cooktop is equipped with burners and/or a hotplate with different diameters. Use pots and pans whose bottom diameter is equal to that of the burners and hotplate, or slightly larger. Only use flat-bottomed pots and pans. The pots and pans must not overlap the control panel.
gb61591.fm5 Page 16 Wednesday, May 29, 2002 2:19 PM Care and maintenance Cleaning the cooktop surface, panstand grids and control panel Before cleaning the cooktop, disconnect it from mains power supply and wait until it has cooled down. Wipe with a cloth moistened with hot water and soap or diluted liquid detergent. Do not use abrasive or corrosive products, chlorine products or steel wool. Do not use vapour cleaning appliances. Do not use flammable products.
4gb61591.fm5 Page 17 Wednesday, May 29, 2002 2:19 PM Troubleshooting guide 1. The burner fails to ignite: Is the main gas delivery valve open? Has the delivery of the town gas (methane) been suspended? Is the gas cylinder (liquid gas) empty? Are the openings of the burner clogged? Have the cap and burner been positioned correctly after cleaning? (See paragraph Care and Maintenance.) 2.
4gb61591.fm5 Page 18 Wednesday, May 29, 2002 2:19 PM Installation Technical information for the Installer This cooktop can be embedded in a worktop 20 to 50 mm thick. If there is no oven beneath the cooktop (any oven installed must be manufactured by us and equipped with a cooling system), insert a separator panel at a minimum distance of 20 mm from the bottom of the cooktop.
4gb61591.fm5 Page 19 Wednesday, May 29, 2002 2:19 PM Installation Assembly Apply the supplied gasket to the cooktop (if not yet fitted), after having cleaned its surface as shown in the relevant figure. To secure the cooktop, use brackets (A) supplied with it. 1. Fit the brackets into the relevant bores and fasten them by means of their screws. 2. Make an opening in the worktop, respecting the dimensions indicated in the enclosed Product Description Sheet. 3. Install the cooktop in the worktop.
4gb61591.fm5 Page 20 Wednesday, May 29, 2002 2:19 PM Installation Connection to gas supply The gas supply system must comply with local regulations. You can find specific local regulations for some countries, in the separate National Safety Regulations Sheet supplied. If no information concerning your Country is given, please ask details to your Installer.
4gb61591.fm5 Page 21 Wednesday, May 29, 2002 2:19 PM Installation ADJUSTMENT TO DIFFERENT TYPES OF GAS If a different type of gas from the one indicated in the plate is used, the cooktop must be adapted to it. Use pressure regulators suitable for the gas pressures indicated in the separate Product Description Sheet. 4. The gas nozzles must be changed by After Sales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After Sales Service. 5.
