Manual

5. Lift and pull the washer assembly forward out of the cabinet. From this position it is possible to
service all the washer components, which are similar to those used in other Whirlpool direct drive
washers.
6. When reinstalling the washer mechanism, it is important to insure that the base restraints are
properly positioned and that the wiring harness, drain hose, vacuum break, and pressure hose
are properly installed and positioned.
Dryer Access
A WARNING
ill.
Electrical Shock Hazard
Disconnect electric power from appliance before servicing.
vggi
Replace all panels before operating.
w
Failure to do so could result in death or electrical shock.
Control Panel Access
1. Remove the three (3) screws that hold the
Control Panel in place. (Fig. 18)
2. Remove the transition panel by removing
the three (3) retaining screws. (Fig. 18)
The wiring diagram is located on the back
side of the transition pane!
Screws
3. Lift the console up and flip it forward, being
careful not to damage the knobs or the dryer
front panel. (Fig. 19)
Fig. 19
Front
Panel
Transition
Panel
Retaining
Screws
Fig. 18
Start
Switch
Dryer
Timer
Washer
Timer
Water
Temperature
Switch