Manual

PROBLEM
POSSIBLE CAUSE
7. KNOCK DURING
Agitator splines worn
Replace agitator
AGITATE.
Excessive clearance on pinion
thrust or main drive gear
Replace gearcase
8. TRIES TO AGI
TATE DURING SPIN.
Shift actuator or cam damaged
Replace gearcase
9. WATER DOES NOT
Clogged drain
Remove obstruction
DRAIN FROM
Pump
Replace pump
MACHINE.
Drain hose kinked
Relocate hose to prevent kink
10. SLOW OR NO
Lid open
Close lid
SPIN.
Lid switch defective
Check continuity
NOTE; In diagnosing this
problem, start the washer in
Lid switch disconnect plug open
Check plug engagement
Wiring harness
Check continuity
spin and see if the clutch
Timer switches
Check continuity
drum spins. If it spins, the
problem is nof inside the
gearcase. Ifthe clutch drum
does not spin, all orsome of
Motor
See problem 1
Cam driver broken
Replace driver
Weak clutch spring
Replace spring
the problem is inside the
Spin tube
Óheck bearings and replace
gearcase.
Clothes between basket and tub
Remove
Worn Clutch Lining
Replace clutch
11. MACHINE WILL
Water inlet valve
Check voltage
NOT SPRAY
Water temp, switch (if used) Check continuity
RINSE.
Timer switches
Check continuity
Wiring harness
Check continuity
12. EXCESSIVE
Not level
Level
VIBRATION OR
Front leveling leg locknuts not
Secure locknut against frame after
MACHINE
tight _
leveling
WALKS. Weak floor Advise customer
Unbalanced load
Redistribute load
Shipping pins not removed
Remove pins
Rear leveling legs stuck Loosen
Suspension plate sticky
Replace plate
Suspension plate damaged or
worn
Replace plate
Suspension pads damaged or
worn
Replace pads
Tub support friction area sticky
Replace tub support
Tub support damaged or worn
Replace tub support
Suspension springs missing
Broken or not connected
Replace or reconnect springs
Basket ballast missing
Replace basket balance ring
Base bent/out of square
Replace base
17