! ! " # $ % & ' & " ( ) % 9
! " 1. Removing the packaging and check • • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous. 2.
# 1) For Great Britain only 2) For the Republic of Ireland only Warning - this appliance must be earthed The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1.
1. Packing 3. Disposing of packaging and old appliances. The packing box may be fully recycled as confirmed by the recycling symbol. 2. Energy saving tips • • • • • • • • Always dry a full load: depending on the type of laundry and the programme/ drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. Do not overdry the laundry.
A. Work top B. Contact pin A C. Door To open the door: pull the handle. To close the door: push gently until closed. D. Filter B D C Reminder - Maintenance and Cleaning Filter Clean the lint filter at the end of every drying cycle: Open the door. Pull the filter upwards. Remove lint using a soft brush or your fingertips.
$ In some dryer models the vent hose together with an adaptor is supplied in the drum. If the hose and adaptor are not supplied as a standard the optional accessory AMH 577 kit, available at your dealer, can be used. Installing the vent hose A. Place a towel or the packing material on the right-hand side next to the dryer. B. Place the dryer on its righthand side (seen from the front) on the towel or the packing material. C. Push the adapter into the hose (see illustration).
% & Door Reversibility C A. Unplug the dryer. B. Open the door. C. Using a spanner, turn the contact pin on the inside of the door (top) through 90° and remove it. D. Remove the 2 door hinge screws, followed by the door. E. Unscrew the 2 screws above and below the door lock system. C F. Removing the door lock: using a screwdriver, press down on the small rib in the upper opening and extract the door lock by pulling it towards you. G. Reverse the door: H.
' & " ( ) % Troubleshooting Guide After-Sales Service If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our AfterSales Service (refer to guarantee).