CONTENTS Please read instruction for use QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE INSTALLATION OF THE DRYER Page 14 SAFETY ADVICES AND GENERAL RECOMMENDATIONS Page 16 ELECTRICAL CONNECTION Page 18 DESCRIPTION OF THE DRYER Page 19 MAINTENANCE AND CLEANING THE DOOR FILTER Page 19 CLEANING THE BOTTOM FILTER P
INSTALLATION OF THE DRYER • The dryer must only be transported in upright position. • The dryer shall only be transported or lifted by two persons. • The dryer is exclusively destined to dry dryable laundry in quantities which are usual for private households. • Observe the instructions given in this instruction for use and the programme chart before using the dryer. • Keep the instruction for use and the programme chart.
• If the dryer has to be installed due to lack of space directly next to a gas or coal stove, a heat insulating plate (85 x 57 cm) has to be installed in between, whose side against the stove has to be covered with aluminium foil. D. Fix both distance holders by turning them in clockwise direction until stop position. D 4.
SAFETY ADVICES AND GENERAL RECOMMENDATIONS • To minimize the risk of fire in a tumble dryer, the following should be observed: • Oil-affected item can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the item can become hot enough to catch fire. Piling, stacking or storing oilaffected item can prevent heat from escaping and so create a fire hazard.
Packing • The packing box may be fully recycled as confirmed by the recycling symbol. Disposing of packaging and old Dryer: • The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • When drying cotton, dry iron dry and cupboard dry loads together. Start with the iron dry programme/ drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting.
ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1 363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1 362 type and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Reinstall both into plug.
DESCRIPTION OF THE DRYER A A. Work top B. Water container B C. Contact pin C D. Door: To open the door: pull the handle. To close the door: push gently until closed. E. Door filter F. Bottom filter D G. Bottom filter flap E F G MAINTENANCE AND CLEANING THE DOOR FILTER AFTER EACH DRYING CYCLE • Switch off the dryer before cleaning or carrying out maintenance. • Empty the water container at the end of each drying cycle. • Clean the door filter at the end of every drying cycle.
CLEANING THE BOTTOM FILTER A A. Open the bottom filter flap and set it aside. Lift up the handle of the filter and pull the bottom filter out. B. Open the filter by lifting on the latch of the filter frame. C. Take out the foam from the inside of the filter. B D. Remove the lint on the surface of the foam by hand. Afterwards, clean the foam under running water to remove any remaining lint from the foam. E. Remove the lint from both filter parts by hand.
DRAINAGE SYSTEM For your convenience: The dryer can be connected directly to the sewage system of the house to avoid the emptying of the water container after each drying cycle. Place an absorbent cloth underneath to collect water spillage. C. Fix the hose to the sewage system. The height difference between the floor where the dryer stands on and the connection at the sewage system should not exceed 1 m. C A. Unplug the hose located at the upper rear part of the dryer.
DOOR REVERSIBILITY For your convenience: A In case you want to stack the dryer on a washing machine, you can reverse the door opening direction, to bring the door handle in a lower position. A. Unplug the dryer. B. Open the door. C. Using a pliers, turn the contact pin (B) in the upper part of the door by 90° and pull it out. B D. Removing the door lock: Unscrew the 2 screws above and below the door lock system. E.
FAILURE CODES In case of a malfunction of the dryer, one the following failure codes could be displayed. FAILURE CODE You can check yourself before calling the After-Sales Service. F01 – F04 Please call the After-Sales Service. F05 Turn the dryer OFF and unplug it. Make sure that the room temperature is between 5°C and 35°C. Wait for 1 hour. Plug the dryer back in and restart it. If the failure reoccurs, please call the After-Sales Service. F06 Turn the dryer OFF and unplug it.
TROUBLESHOOTING GUIDE/AFTER-SALES SERVICE If a fault occurs, before contacting our After-Sales Service, perform the following checks to try to remedy the problem: Water droplets underneath the dryer: Drying takes too long / laundry is not dry enough: • Any lint on the door seal removed? • Correct programme selected? • Water container positioned correctly? • Inserted laundry too wet (Washing machine spin speed less than 800 rpm? When the spinning speed is less than 800 rpm the water container fault may
