CONTENTS QUICK REFERENCE GUIDE PLEASE READ INSTRUCTIONS FOR USE BOOKLET! PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET BEFORE USING THE DRYER Page 14 PRECAUTIONS AND GENERAL RECOMMENDATIONS Page 16 ELECTRICAL CONNECTION Page 18 DESCRIPTION OF THE DRYER Page 19 REMINDER - MAINTENANCE AND CLEANING Page 19 CLEANING THE LINT FILT
BEFORE USING THE DRYER • This dryer is exclusively designed to dry machine dryable laundry in quantities which are usual for private households. • Observe the instructions given in these Instructions For Use and the Programme Chart before using the dryer. • Keep the Instructions For Use and the Programme Chart handy for reference. If you pass on the dryer to others, make sure that the Instructions For Use and the Programme Chart go with it.
• The dryer is not designed for built-in installation. • The dryer can be installed under a worktop, provided that adequate ventilation of the dryer is assured. Install a ventilation grid (minimum 45 cm x 8 cm), in the rear part of the worktop under which the dryer is installed. D. Secure both distance holders by turning them in a clockwise direction as far as the stop position. D 4.
PRECAUTIONS AND GENERAL RECOMMENDATIONS To minimise the risk of fire in the tumble dryer, the following precautions should be observed: • Oil-soaked items ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the item can become hot enough to catch fire. Piling, stacking or storing oil-soaked items can prevent heat from escaping and so create a fire hazard.
Packaging • The packaging box is 100% recyclable, as confirmed by the recycling symbol. • Always set the program selector knob to the “0” position after the end of the cycle. Disposing of packaging and old appliances • The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • Before scrapping cut off the power cable so that the dryer cannot be connected to the mains.
ELECTRICAL CONNECTION 1) For United Kingdom only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an ASTA marked fuse, approved to BS 1362 and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug. Important: The fuse cover must be refitted when changing a fuse.
DESCRIPTION OF THE DRYER A. Work top B. Water container C. Contact pin D. Door: To open the door, pull the handle. To close the door, push gently until closed. E. Filter F. Heat exchanger G. Heat exchanger flap REMINDER - MAINTENANCE AND CLEANING Before cleaning or carrying out maintenance, switch off the dryer. AFTER EACH DRYING CYCLE • Clean the lint filter at the end of every drying cycle. • Empty the water container at the end of each drying cycle.
CLEANING THE HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every month, or whenever the heat exchanger indicator lamp lights up (optional feature, depending on the model of your dryer), proceeding as follows. A. Open the heat exchanger flap and put it to one side. A B. Turn the two locking bars at the side of the heat exchanger towards the middle, to the horizontal position, and pull the heat exchanger out. B C.
DRAINAGE SYSTEM For your convenience: The dryer can be connected directly to the sewage system of the house to avoid having to empty the water container after each drying cycle. C. Connect the hose to the sewage system. The height difference between the floor where the dryer is positioned and the sewage system connection should not exceed 1 m. Place an absorbent cloth underneath to collect water spillage. A. Unplug the hose located at the upper rear part of the dryer.
DOOR REVERSIBILITY For your convenience: In case you want to stack the dryer on a washing machine, you can reverse the door opening direction, to lower the position of the door handle. Unplug the dryer. A A. Open the door. B. Using a spanner, turn the contact pin (B) in the top part of the door through 90° and pull it out. B C. Remove the door lock: Unscrew the 2 screws above and below the door lock system. C D.
TROUBLESHOOTING GUIDE/ AFTER-SALES SERVICE In the event that the dryer malfunctions, one of the following failure codes may be displayed. Depending on the model of your dryer, the failure may be displayed in letters or by different blinking LEDs. Failure code LED failure code Check to be carried out by customer before service call F01 Please call the After-Sales Service. F02 Please call the After-Sales Service. F03 Please call the After-Sales Service. F04 Please call the After-Sales Service.
TROUBLESHOOTING GUIDE/ AFTER-SALES SERVICE If a fault occurs, before contacting our AfterSales Service, perform the following checks to try to remedy the problem: Drying takes too long / laundry is not dry enough: • Correct programme selected? • Laundry too wet (Washing machine spin speed less than 1000 rpm? When the spin speed is less than 1000 rpm a water container fault may occur during the drying cycle).
