CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS PAGE 4 ELECTRICAL CONNECTION PAGE 5 SAFETY ADVICES AND GENERAL RECOMMENDATIONS PAGE 6 DESCRIPTION OF THE DRYER PAGE 8 REMINDER - MAINTENANCE AND CLEANING PAGE 8 DRAINAGE SYSTEM PAGE 9 DOOR REVERSI
SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. • If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. • Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug.
SAFETY ADVICES AND GENERAL RECOMMENDATIONS 1. Packing 2. • • • • • • • • 3. • 4. 5. • • • • • • 6 The packing box may be fully recycled as confirmed by the recycling symbol . Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle.
• The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. • Attention rear panel can be hot.
DESCRIPTION OF THE DRYER A. Work top. B1.Water Container bottom version or B2.Water Container top version. C. Contact pin. D. Door: To open the door: pull the handle. To close the door: push gently until closed. E. Filter. F. Child Safety Lock. G. Button for heat exchanger flap opening. H. Heat exchanger. A B2 C F E D G Note: Depending on the model, the opening of the flap can be horizontal or vertical. This doesn’t change the functioning of the flap.
DRAINAGE SYSTEM For water container top only B To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: normally the drain hose is not supplied; the accessory kit, available at your dealer or our After-Sales Service should be used. Please contact your dealer or our After-Sales Service to get the reference of this accessory, which should be used. The connection for direct draining is at the rear of the dryer. A.
DOOR REVERSIBILITY / CHILD SAFETY LOCK Door Reversibility C A. Unplug the dryer. B. Open the door. C. Using a spanner, turn the contact pin in the upper part of the door by 90° and remove it. D. Unscrew the 2 screws of the door hinge and remove the door. E. Removing the door lock: Unscrew the 2 screws above and below the door lock system. Lift the door lock from the bottom, sliding it upwards about 1.5 cm, and remove it. F. Reverse the door: Fasten the door on the desired side with the 2 screws.
HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every month, proceeding as follows: A A. Open the door and press the heat exchanger flap button on the bottom of the door entrance. B. The heat exchanger flap opens. C. Fold the heat exchanger handle upwards to the horizontal position and remove the heat exchanger. D. Clean the heat exchanger under running water by turning it around to reach all sides, especially in front and behind. E.
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide After-Sales Service If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee).
