Owner's Manual

ManualsBrandsWhirlpool ManualsKitchen15 in. Built-In Trash Compactor in Stainless Steel

THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in

TROUBLESHOOTING, please visit our website at www.whirlpool.com or call us at 1-800-253-1301.

You will need your model and serial number located on the right-hand side, behind the compactor drawer.

TABLE OF CONTENTS

COMPACTOR SAFETY ....................................................................................2

INSTALLATION REQUIREMENTS ................................................................... 3

INSTALLATION INSTRUCTIONS ..................................................................... 4

COMPACTOR USE ...........................................................................................7

COMPACTOR CARE ........................................................................................9

TROUBLESHOOTING ....................................................................................11

WARRANTY ....................................................................................................13

W11034798A

COMPACTOR USER

INSTRUCTIONS

Summary of content (15 pages)

PAGE 1
COMPACTOR USER INSTRUCTIONS THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in TROUBLESHOOTING, please visit our website at www.whirlpool.com or call us at 1-800-253-1301. You will need your model and serial number located on the right-hand side, behind the compactor drawer. TABLE OF CONTENTS COMPACTOR SAFETY.....................................................................................2 INSTALLATION REQUIREMENTS....................................
PAGE 2
COMPACTOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.
PAGE 3
INSTALLATION REQUIREMENTS Location Requirement Clearance Dimensions Product Dimensions 341/8" (86.7 cm) 24" (61.0 cm) 15" (38.1 cm) A B A. Leave 6" (15.2 cm) of clearance space to the right side of the compactor in order to remove the compactor bags. B. Leave 23" (58.4 cm) of clearance in front of the compactor in order to fully open or remove the compactor drawer. Cutout Dimensions Electrical Requirements WARNING 3" min. (7.6 cm) A 341/4" min. (87.0 cm) 24" min. (61.
PAGE 4
INSTALLATION INSTRUCTIONS To install handle: Tools Installer: Leave User Instructions with the homeowner. Homeowner: Keep User Instructions for future reference and for local electrical inspector’s use if required. Tools needed: Insert screws into the holes from the inside of the drawer. Place handle on the front of the drawer and align handle screw holes with screw ends. Tighten screws snugly.
PAGE 5
Height Adjustment (optional) 1. Measure the height of your cabinet opening. The top of the compactor mounting screw head should be at least 1/8" (3 mm) from the top of the cabinet opening. The rear wheels are preset for a cabinet height of 341/4" (87 cm). See Position “1” in the following picture. To adjust for cabinet opening heights greater than 341/4": Loosen self-tapping screw just enough to clear stud from hole in Position “1”.
PAGE 6
Countertop Mounting 3. Use a ruler and a pencil or chalk to draw a line between the marks on each side of toe guard. Use scissors or a utility knife to cut toe guard along line. Countertop Retaining bracket Mounting screw (provided) NOTE: If the retaining brackets cannot be attached to the underside of countertop, see the “Cabinet-face Mounting” section. Cabinet-face Mounting (use if countertop mounting is not possible) Mounting clip (provided) Retaining bracket 4. Replace drawer.
PAGE 7
Secure the custom panel to the exterior drawer front by using four #8 x 1" wood screws from the inside drawer front. There are seven holes available for use. 2. Attach a 15" x 1/2" (38.1 cm x 13 mm) quarter-round filler along the top inside edge of the drawer front using glue or screws.
PAGE 8
Starting Your Compactor Key-knob 1. Lift and pull the handle or press the foot pedal to open the drawer. 2. Remove top of bag from bag retainer buttons. Pull up all four bag cuffs. Close bag with a twist tie. 3. Release drawer side latch. Tilt drawer to the right. This releases pressure on the bag making it easier to remove the bag. 1. Open drawer. Load trash. 2. Turn the Key-knob to the ON position. 3. Set Compress cycle switch to OFF. 4. Close drawer. NOTE: The Key-knob is removable.
PAGE 9
NOTE: An unlatched drawer can cause the drawer monitor switch to stay open. This will make the ram return and the compactor will continue to run. Attempt to push the drawer inwards to stop the compactor. The continuous running of the compactor can also be attributed to debris in the drawer area. If it is difficult to open or close the drawer this may be due to either the drawer latch not being locked or debris in the drawer area. 1. Place folded bag into the drawer.
PAGE 10
Cleaning Inside the Cabinet 1. Pull the drawer out until it stops. Cleaning Exterior Surfaces 1. Wash exterior surfaces (including stainless steel) with a clean sponge or soft cloth and a mild detergent in warm water. Do not use abrasive or harsh cleaners. Rinse and dry thoroughly with a soft cloth. 2. Wipe up spills immediately. Some foods can damage the finish if left on the compactor surface. Cleaning the Ram 1. Wipe glass particles off of the ram cover with a cloth or paper towels.
PAGE 11
TROUBLESHOOTING Try the solutions suggested here first in order to avoid the cost of an unnecessary service call. PROBLEM SOLUTION COMPACTOR WILL NOT OPERATE Check that the power supply cord is plugged into a grounded 3 prong outlet. Check the type of wall plug the compactor is plugged into. It is possible the compactor power cord is plugged into an outlet controlled by a wall switch. This can occur when the wall switch was meant for a garbage disposal outlet.
PAGE 12
PROBLEM SOLUTION COMPACTOR WILL NOT TURN OFF Push on the drawer front to attempt to engage the drawer monitor switch. Open drawer and be sure the latch is locked. The foot actuated Start switch may not be engaged or the lever that pushes the Start switch in may be bent. Push on the lever to stop the compactor. If needed, bend the lever back into position. Debris in the drawer area will cause the door to disengage from the drawer monitor switch causing the compactor to keep running.
PAGE 13
WHIRLPOOL® COMPACTOR LIMITED WARRANTY ATTACH YOUR RECEIPT HERE. PROOF OF PURCHASE IS REQUIRED TO OBTAIN WARRANTY SERVICE. Please have the following information available when you call the Customer eXperience Center: ■■ ■■ ■■ ■■ Name, address and telephone number Model number and serial number A clear, detailed description of the problem Proof of purchase including dealer or retailer name and address IF YOU NEED SERVICE: 1.
PAGE 14
NOTES 14