Instruction booklet TUMBLE DRYER GB English, 1 Contents Installation, 2 Warnings, 4 Care and maintenance, 6 Control Panel, 7 The Display, 8 Start and Programmes, 9 Laundry, 13 Troubleshooting, 14 Service, 16 TVF 75 C www.aristonchannel.com This symbol reminds you to read this instruction manual. ! Keep this instruction booklet on hand in order to refer to it when necessary.
Installation Where to install the tumble dryer Window ventilation hole If the dryer is installed below a worktop, ensure there are 10 mm between the upper panel of the dryer and any objects above it, and 15 mm between the sides of the machine and the walls or furniture units adjacent to it. This en15 mm 15 mm sures adequate air circulation. Make sure the air inlets on the rear panel are not blocked or obstructed.
Electrical connections Before plugging the appliance into the socket, check the following: Make sure your hands are dry. The socket must have an earth connection. The socket must be able to withstand the machine’s maximum power output as indicated on the rating plate (see Description of the tumble dryer). The power supply voltage must fall within the values indicated on the rating plate (see Description of the tumble dryer). Do not use extension leads. Do not pull the power supply cable.
Warnings GB ! This appliance has been designed and built according to international safety standards. These warnings are given for safety reasons and must be followed carefully. General safety •This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
rubber (also known as latex foam), or similarly textured rubber like materials. Foam rubber materials can, when heated, produce fire by spontaneous combustion. • Fabric softener or similar products should not be used in a tumble dryer to eliminate the effects of static electricity unless the practice is specifically recommended by the manufacturer of the fabric softener product. • Do not tumble dry undergarments that contain metal reinforcements eg. bras with metal reinforcing wires.
Care and maintenance GB Disconnecting the power supply ! Disconnect the dryer when not in use or during cleaning and maintenance operations. Cleaning the filter after each cycle The filter is a fundamental component of the dryer: its function is to collect lint and fluff that form during drying. Clean the filter once drying is completed, by rinsing it under running water or cleaning it with a vacuum cleaner.
Control panel GB PROGRAMME knob Indicator 1 16 10 9 8 7 ON/OFF Button HEAT LEVEL Button & Lights 15 14 13 12 1 1 6 5 4 3 2 Key Lock Button & Light Display Unit & Selection Buttons OPTION Buttons & Lights START/PAUSE Button & Light The ON/OFF button : If the dryer is running and this button is pressed and held for more that 3 seconds the dryer is turned off, it counts down 3, 2, 1, Off and the programme is then cancelled. Press and hold for more than 3 seconds and the dryer reactivates.
The Display GB The Display has three main functions, each with its corresponding button. Dryness Sensing Levels After selecting a programme that has a Sensor Dry option, press and release the button until the required dryness sensing level is displayed. If the sensing option is not available with your selected programme, the display will flash and the buzzer will beep three times. ! Some sensing programmes do not have all 5 dryness level options available.
Start and Programmes Choosing a Programme GB 1. Plug the dryer into the electrical socket. 2. Sort your laundry according to fabric type (see Laundry). 3. Open the door and make sure the filter is clean and in place (see Maintenance). 4. Load the machine and make sure that the items are not in the way of the door seal. Close the door. 5. Press the On/Off Button . 6.
GB n° Programme Max. load Description of program The duration of the drying cycles can be checked on the display1. Notes/ Options available • 1 Cotton. max 2 Shirts 3 kg 3 Delay Timer - Crease Care or Sound High heat option • This is a programme for shirts made from cotton. Medium heat option • This is a programme for shirts made from synthetic materials or a mixture of natural and synthetic materials, such as polyester and cotton.
n° Programme Max. load 9 Silk 11 Delicates Lingerie Baby Programme 2 kg This is a programme for drying your very delicate lingerie, including silk. Close all hooks, buttons or zips before drying. Loads dried using the Cupboard Dry setting are usually ready to use, but on some garments the edges may be slightly damp. If this is the case, try opening them out or turn items inside out and running the programme again for a short period.
GB The Controls ! Warning, after pressing the START/PAUSE button , the programme cannot be changed. To change a selected the light programme, press the START/PAUSE button flashes Amber to indicate the programme is paused. Select the new programme and any options required, the light will then flash green. Press the START/PAUSE button again and the new programme will start. • Option buttons These buttons serves to personalise the selected programme according to personal requirements.
Laundry Sorting laundry Drying times • Check the symbols on the care labels of the various garments to verify whether the garments can be safely tumble dried. • Sort laundry according to the type of fabric. • Empty all pockets and check for loose buttons. • Close zips and hooks and fasten belts and strings without tightening them. • Wring out garments to remove the maximum amount of water possible.
Troubleshooting GB One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: Problem: Possible causes / Solution: The tumble dryer won’t start. • The plug is not plugged into the socket, or not making contact. • There has been a power failure. • The fuse has blown. Try to plug another appliance into the socket. • You are using an extension cord? Try to plug the dryer’s power cord directly into the socket.
Comparative Programmes • GB Programmes recommended for comparative test to AS/NZ 2442.
Service 12/2016 - Xerox Fabriano GB Before calling the Service Centre: Spare Parts • Use the troubleshooting guide to see if you can solve the problem yourself (see Troubleshooting). • If not, turn off the dryer and call the Service Centre closest to you. This dryer is a complex machine. Repairing it yourself or having a nonauthorised person try to repair it could cause harm to one or more persons and to the machine, and could invalidate the spare parts warranty.