Owner's Manual

13
CONTROLS AND CYCLE STATUS
Press to start or resume a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator LED ashes.
The cycle will not resume until door is closed and the Start/Resume keypad is pressed.
NOTE: Push door rmly closed within 4 seconds of pressing the Start/Resume keypad or the dishwasher
will not start. If door is not closed within 4 seconds, the Start/Resume LED will ash and an audible tone
will sound when the door is closed.
Press to cancel a wash cycle.
Close the door rmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely.
Display varies by model The display allows you to follow the progress of the dishwasher cycle.
Models with a numeric display count down while the cycle is running. If you open the door to view this
display, you must resume the cycle by pressing the Start/Resume keypad and closing the door within
4 seconds.
Models without a numeric display have indicators that glow for Drying, Clean, and Sanitized.
If you select Sani Rinse option, when cycle is nished, the “Sanitized” indicator glows. If your dishwasher
did not properly sanitize your dishes, the light ashes at the end of the cycle. This can happen if the cycle
is interrupted or water could not be heated to required temperature. The light goes off when you open and
close door or press Cancel.
The exterior status light on the front of the door panel will glow blue when washing, red while it is drying,
and white when the cycle is complete.