Instruction for Use

GB
37
2. Choose which shelf
to use with the sliding
rack. Paying attention
to the direction in which
the sliding rack is to be
extracted, position joint
B and then joint C on
the frame.
3. Secure the two frames
with the guide rails using
the holes provided on
the oven walls (
see
diagram
). The holes for
the left frame are
situated at the top, while
the holes for the right
frame are at the bottom.
4. Finally, fit the frames
on the spacers A.
! Do not place the sliding racks in position 5.
Automatic cleaning by PYROLYSIS
The cleaning cycle can cause the internal
temperature of the oven to reach 500°C. The
pyrolytic cycle is activated, burning away food and
grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause
for concern: this process is both normal and hazard-
free.
Before initiating the PYROLYTIC cycle:
• clean the oven door;
• remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not
use detergents;
• remove all accessories and the sliding rack kit
(where present);
• do not place tea towels or pot holders over the
oven handle.
! If the oven is too hot, the pyrolytic cycle may not
start. Wait for the oven to cool down.
! The programme may only be started once the oven
door has been closed.
To activate the cleaning cycle
:
1. Press
to switch on the control panel.
2. Press the
icon.
3. Scroll through the menu commands using the
control dial, select PYROLYTIC and press
.
4. The appliance suggests a “NORMAL” pyrolytic
cycle, with a duration of 1 hour 30 minutes. Other
levels of cleaning may be selected.
• Use the control dial to select one of the following:
- “ECONOMY”: duration 1 hour
- “NORMAL”: duration 1 hour and 30 minutes
- “INTENSIVE”: duration 2 hours.
• Press
again.
5. Press
to begin the PYROLYTIC cycle.
Safety devices
• The door locks automatically as soon as the
temperature reaches a high value; the
icon
lights up on the display.
• Pressing the
icon cancels the cleaning cycle
at any time.
• If a malfunction occurs, the heating elements will
be switched off.
• Once the oven door has been locked, you cannot
change the duration and end time settings.
Programming delayed automatic cleaning
! Programming is possible only after selecting the
cleaning cycle.
1. Press the
icon twice; the end of pyrolysis
time will begin to flash.
2. Turn the control dial to adjust the end of pyrolysis
time; hold the dial in this position to scroll through
the numbers more quickly and make the setting
process easier. The display will show a graphic
indicating the delayed start in bar format.
3. Once you have reached the desired end time,
press the
icon again. The delayed start bar will
show the current time, the time remaining until the
start of pyrolysis, the duration and the end of
pyrolysis time as a graphic.
4. Press
to begin the pyrolysis schedule.
5. The display shows the remaining time, moving the
delayed start bar backwards.
6. Once pyrolysis has begun, the display will
indicate the remaining time by filling the duration
bar.
6. When the time has elapsed, “CLEANING CYCLE
FINISHED” appears on the display and a buzzer
sounds.
• For example: it is 9:00 a.m. and the Economy
PYROLYTIC cycle has been selected: default set
time 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30 a.m.
D
B
C
Left
guide rail
Right guide
rail
Direction
of extraction