Owner's Manual
Table Of Contents
8
5. Mark hole locations
Lift the range hood into place and insert the mounting bracket
tabs through the slots in the back of the range hood.
Hold the range hood rmly in place with one hand and
bendeach mounting tab (A) upward approximately 90°.
Mark the hole at the power supply knockout (B).
Mark the 4 vent hole locations (C) on the top of the range hood.
OPTIONAL: Mark the hole in each mounting tab.
Remove the range hood and set it aside.
6. Mark and cut vent opening
7" (17.8 cm) Round Vent System
■ Using the 7" (17.8 cm) round vent mounting plate, draw
thevent opening outline on the underside of the cabinet:
- Place the vent mounting plate on the bottom of the
cabinet. Position the edge of the plate with the widest
distance (A) between the hole and edge of the mounting
plate against the wall. Position the side edges of the
mounting plate between the dots marked previously.
IMPORTANT: The widest edge (A) of the vent
mountingplate must be positioned against the wall.
- Trace the 7" (17.8 cm) vent opening (solid line)
onthecabinet bottom.
■ Using a jigsaw or keyhole saw, cut the vent opening
1"(2.5cm) larger than the 7" (17.8 cm) hole traced
(dashedline).
7. Drill electrical opening
Using a 1
1
/
4
" (3 cm) drill bit, drill the hole in the dot
markedpreviously at the electrical strain relief.
OPTIONAL: Using a 1/8" (3 mm) drill bit, drill pilot holes
for thedots marked previously at each mounting tab
atanapproximate 45° angle in an upward direction.
C
B
A
C
A
90˚
1"
(2.5 cm)
A