Owner's Manual
Table Of Contents
6
INSTALLATION INSTRUCTIONS
1. Disconnect power
2. Mark hole locations
Align the exterior edge of the mounting brackets
withtheexterioredges of the upper cabinet.
IMPORTANT: The brackets should touch the upper cabinet.
With a pencil, mark the upper holes on the brackets.
3. Install brackets
■ Using a #2 Phillips screwdriver, install the drywall anchors.
■ Using #8-18 x 1" (4.2 x 25 mm) at-head #2 Phillips screws,
install the mounting brackets using the upper holes.
NOTE: For installations to a surface other than drywall,
itisrecommended that a qualied contractor determine
theanchoring method.
4. Prepare Range Hood
■ Set the range hood on its back on a covered surface.
■ Using a #2 Phillips screwdriver, remove the electrical
boxcover.
■ Using a at-blade screwdriver, remove the appropriate
powersupply knockout.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.