Use & care guide

9
Secure the Drain Hose
1. Drape the power cord over the washer top.
2. Secure the drain hose to the laundry tub leg or standpipe with
the beaded strap provided.
(See illustrations A and B.)
A BC
If the washer faucets and the drain standpipe are recessed
(see illustration C), put the hooked end of the drain hose in
the standpipe. Tightly wrap the beaded strap around the
water inlet hoses and the drain hose.
Do not force excess drain hose into the standpipe.
Level the Washer
Properly leveling your washer avoids excessive noise and vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side to
side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step unt
il washer is level.
2. Make sure all four feet are stable and resting on the floor.
Then check that the washer is perf
ectly level (use a level).
3. After the washer is level, use a 17 mm open-end wrench to
turn the nuts on the feet tightly against th
e washer cabinet.
IMPORTANT:
All four feet must be tightened. If the nuts are
not tight against the washer cabinet, the
washer may vibrate.
4. The washer should not
move front to back, side to side,
or diagonally when pushed on its top edges.
5. S
lide the washer to its final location.
6. Confirm the levelness of
the washer.
Complete Installation
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See “Electrical Requirements.”
2. Ch
eck that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Ch
eck that you have all of your tools.
4. Dispose of/r
ecycle all packaging materials.
5. Check that the water faucets are on.
6. Ch
eck for leaks around faucets and inlet hoses.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
re, or electrical shock.
WARNING
7. Plug into a grounded 3 prong outlet.
8. Read “W
asher Use.”
9. T
o test and clean your washer, make sure there are no clothes in
the washer and add one AFFRESH™ tablet to the washer drum.
Select Power, the Clean Washer cycle and then select START.
This cycle will take approximately 65 minutes to complete. Allow
th
e washer to complete the entire cycle without interruption.