Installation Instructions

ManualsBrandsWhirlpool ManualsWashersW10298318RP

Stack Kit Installation Instructions

For use only with front load washers and dryers

Juego para lavadora y secadora instrucciones de instalación

Para uso sólo con lavadoras y secadoras de carga frontal

Enemble superposé instructions d’installation

Pour utilisation avec laveuses et sécheuses à chargement par l’avant seulement

Table of Contents/ Índice/ Table des matières...................................2

W10315355B

Summary of content (5 pages)

PAGE 1
Stack Kit Installation Instructions For use only with front load washers and dryers Juego para lavadora y secadora instrucciones de instalación Para uso sólo con lavadoras y secadoras de carga frontal Enemble superposé instructions d’installation Pour utilisation avec laveuses et sécheuses à chargement par l’avant seulement Table of Contents/ Índice/ Table des matières...................................
PAGE 2
Table of Contents Índice Table des matières Stack Kit SAFETY................................2 Installation Requirements..........2 Tools and Parts..............................2 Location Requirements.................3 Uninstall Washer and Dryer..........4 If Your Washer or Dryer is Still in Its Packaging.............................4 Installation INSTRUCTIONS............5 SEGURIDAD DEL JUEGO PARA LAVADORA Y SECADORA SUPERPUESTAS.........................................6 REQUISITOS DE INSTALACIÓN.....
PAGE 3
LOCATION REQUIREMENTS Recessed Area and Closet Installation Instructions IMPORTANT: The stacked washer/dryer can be installed in an enclosure. Check the locations of the water supply faucets, grounded electrical outlets, and gas supply line connection (gas dryer only). Depending on your application, longer washer fill hoses, longer electric power supply cords and a longer flexible stainless steel gas connector line than supplied with the washer/dryer may be needed.
PAGE 4
Uninstall Washer and Dryer IMPORTANT: If your washer and dryer are already installed, they must be uninstalled. if your washer or dryer is still in its packaging If you need to uninstall your washer or dryer, see “Installation Instructions” that came with your model for tools required. Position the packaged washer or dryer close to its final position. cut the packaging as follows: Washer: Cut plastic film along dotted cut line around the base. Remove the packaging. Do not remove the shipping bolts.
PAGE 5
INSTALLATION INSTRUCTIONS 8. Remove the plastic clips (2), brackets (2), and pan-head screws (4) from the parts bag. 9. Take a plastic clip (C) and with the flat side facing out, push it down onto the lower edge of the slot (D) in the dryer back. Repeat on other side. C D 1. Move washer close to its final location. Leave room to work behind washer. Do not remove the shipping bolts. 2. Level washer as described in washer “Installation Instructions”. 3.