Installation Instructions

22. Install the metal terminal box suppled with the In-Line Smart

Kit to the top of the range hood electrical box. Use

2 - 3.5 x 6.5 mm screws to secure the terminal box.

Assemble the In-Line Smart Kit

1. Using the T20

Torx

adapter, remove the 3 screws from the

terminal box cover on the in-line housing. Set the screws and

cover aside.

2. Disassemble the in-line housing from the in-line base. Using

the T20

Torx

adapter, remove the 2 screws from inside the

terminal box near the top and the 2 screws located on the

opposite side. Lift the housing off the base and mounting

bracket.

3. Install the vent transition without a backdraft damper to the

bottom of the in-line base. Use the T10 Torx

adapter and

install 2 - 3.5 x 9.5 mm mounting screws to secure the

transition to the base.

4. Place the blower motor inside the in-line housing.

Engage the blower motor spring tabs into the keyhole slots

located at the top of the in-line housing. Push the motor so the

spring tabs are secured into the small neck of the keyhole slots.

6. Locate the 4 screws removed from the blower motor. Use

these 4 screws to secure the motor to the in-line housing.

Tighten with the T20

Torx

adapter.

7. Place the in-line housing (with blower motor installed) near

the in-line base.

A. 3.5 x 6.5 mm screws (2)

B. Metal terminal box

C. Range hood electrical box

A. Terminal box cover

B. Screws (3)

A. In-line housing

B. In-line base

C. Screws (4)

A. In-line base

B. Vent transition (without backdraft damper)

C. 3.5 x 9.5 mm screws (2)

A. Keyhole slots

A. In-line housing

B. Blower motor

C. Screws (4)