Installation Instructions

9. Remove the 2 electrical knockouts from the top of the range

hood electrical box and install a UL listed or CSA approved

plastic strain relief into the front knockout.

10. Remove the 9-pin connector inside the range hood electrical

box. Insert a flat-blade screwdriver into the lateral clips while

removing the connector (see the following illustration).

11. Cut the wire tie that is closest to the 9-pin electrical connector.

12. Mount the cover plate supplied with the In-Line Smart Kit to

close the opening in the electrical box.

NOTE: Bend the cover plate along the perforation so it

conforms to the shape of the electrical box.

13. Run the 3 electrical power wires (black, white and green) and

the cover plate ground wire (green) through the small

electrical knockout in the top of the range hood electrical

box. Secure all 4 wires with 1 - UL listed or CSA approved

wire clamp. Snap the wire clamp into the electrical knockout.

14. Run the 9-pin pigtail electrical connector through the UL

listed or CSA approved strain relief.

NOTE: The 9-pin connector must be inside the range hood

electrical box.

15. Connect the 9-pin connector installed to the 9-pin connector

on the inside of the range hood electrical box.

16. Reinstall the plastic electrical box cover. Use the T10 Torx

and the screws previously removed.

A. Wire tie

B. 9-pin electrical connector (wires)

A. Opening

B. Cover plate

C. Cover plate ground wire

A. Electrical power wires (4)

B. UL listed or CSA approved wire clamp

C. Range hood electrical box

A. UL listed or CSA approved strain relief

B. 9-pin pigtail electrical connector

C. Range hood electrical box