Instructions / Assembly

3
LOCATION REQUIREMENTS
Recessed Area and Closet Installation Instructions
IMPORTANT: The stacked washer/dryer can be installed in
an enclosure. Check the locations of the water supply faucets,
grounded electrical outlets, and gas supply line connection
(gas dryer only). Depending on your application, washer
ll hoses and electric power supply cords longer than those
supplied with the washer/dryer may be needed.
1"
(25 mm)
5"
(127 mm)
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
3"
(76 mm)
3"
(76 mm)
77
7
/8"
(1977 mm)
6"
(152 mm)
1"
(25 mm)
If the water supply faucets, electrical outlets, gas supply line,
or power cord need modication, have a qualied plumber,
electrician, or gas technician make the changes.
Mobile home – Additional installation requirements
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280) or the Canadian
Manufactured Home Standard CAN/CSA-Z240 MH.
Mobile home installations require special parts (listed following),
which are available for purchase from your local dealer or service
center.
Stacked pair must be securely fastened to the oor.
Parts Needed:
■ Mobile Home Installation Kit, Part
Number 346764, needs to be purchased
to accomplish this. Order two kits to
enable you to secure both the front
and the back of the unit to the oor.
Special provisions must be made in mobile homes to introduce
outside air into the dryer. The opening (such as a nearby window)
should be at least twice as large as the dryer exhaust opening.
Uninstalling Your Washer
1. Turn off the hot and cold water faucets.
2. Unplug the power supply cord.
3. Slowly loosen the ll hoses at the faucets to relieve the water
pressure. Use a sponge or towel to absorb the released water.
4. Remove the “HOT” and “COLD” ll hoses from the back
of the washer. Drain water in the hoses into a bucket.
5. Remove the drain hose from the wall drain pipe or utility sink
and drain any water in the hose into a bucket.
Uninstalling Your Electric Dryer
1. Unplug the power supply cord.
2. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
Steam Models Only:
3. Turn off water faucet.
4. Disconnect the water inlet hose from faucet; then drain
the hose into a bucket.
UNINSTALL WASHER AND DRYER
IMPORTANT: If your washer and dryer are already installed,
they must be uninstalled.
If you need to uninstall your washer or dryer, see “Installation
Instructions” that came with your model for tools required.
IF YOUR WASHER OR DRYER IS STILL IN ITS
PACKAGING
Position the packaged washer or dryer close to its nal position.
Cut the packaging as follows:
■ Washer: Cut plastic lm along dotted cut line around the
base. Remove the packaging. Do not remove the shipping
bolts.
■ Dryer: Cut around top and down corners along dotted cut
lines. Discard carton top, corner posts and sides. Leave
carton bottom underneath dryer.