Installation Instruction

4
UNINSTALL WASHER AND DRYER
IMPORTANT: If your washer and dryer are already installed,
they must be uninstalled.
If you need to uninstall your washer or dryer, see the Installation
Instructions that came with your model for tools required.
Uninstalling Your Washer
1. Turn off the hot and cold water faucets.
2. Unplug the power supply cord.
3. Slowly loosen the ll hoses at the faucets to relieve the water
pressure. Use a sponge or towel to absorb the released
water.
4. Remove the “HOT” and “COLD” ll hoses from the back
of the washer. Drain water in the hoses into a bucket.
5. Remove the drain hose from the wall drain pipe or utility sink
and drain any water in the hose into a bucket.
Uninstalling Your Electric Dryer
1. Unplug the power supply cord.
2. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
Steam Models Only:
3. Turn off water faucet.
4. Disconnect the water inlet hose from faucet, then drain the
hose into a bucket.
Uninstalling Your Gas Dryer
1. Unplug the power supply cord.
2. Turn off the gas supply.
3. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
4. Disconnect the flexible gas supply line from the dryer. Put
a piece of tape over the open ends of the gas line connection
fittings.
Steam Models Only:
5. Turn off water faucet.
6. Disconnect the water inlet hose from faucet, then drain the
hose into a bucket.
Position the packaged washer or dryer close to its nal position.
Cut the packaging as follows:
n
 Washer: Cut plastic lm along dotted cut line around the
base. Remove the packaging. Do not remove the shipping
bolts.
n
 Dryer: Cut around top and down corners along dotted cut
lines. Discard carton top, corner posts, and sides. Leave
carton bottom underneath dryer.
IF YOUR WASHER OR DRYER IS STILL
IN ITS PACKAGING