4gb05103.
4gb05103.
4gb05103.
gb05103.fm Page 6 Thursday, August 14, 2003 11:57 AM Before Using The Washing Machine 1. Remove the packaging and check • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer • Check that the accessories and supplied parts are all present • Keep the packing material (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous 2.
4gb05103.
4gb05103.fm Page 8 Thursday, August 14, 2003 11:57 AM Installation Remove the transport bolts Adjusting the feet 1. Slacken the four bolts with the spanner supplied. 2. Remove by hand. 3. Grip the bolt and remove it through the large aperture. 4. Seal the resulting holes using the plastic caps supplied; insert the covers in the wide part of the hole and slide them toward the narrow part until they click into place. 5. Retain transit bolts.
4gb05103.fm Page 9 Thursday, August 14, 2003 11:57 AM Worktop for built-under models The appliance must only be installed beneath a continuous worktop. The appliance may only be built under using the intermediate cover panel of the UBS base set. This can be obtained from specialist dealers or After-Sales Service. Connect the water inlet hose For models with straight hose: 1. Insert the mesh filter (already premounted on the hose end or included in the accessories) into the threaded tap coupling. 2.
4gb05103.fm Page 10 Thursday, August 14, 2003 11:57 AM Precautions and General Recommendations 1. Packaging • The packaging is 100% recyclable and is marked with the recycling symbol. Adhere to current local regulations when disposing of packaging material 2.Disposing of packaging and old washing machines • The washing machine is built from reusable materials.
4gb05103.fm Page 11 Thursday, August 14, 2003 11:57 AM Description Of The Washing Machine 1. 2. 3. 4. 5. 6. 7. 8. 9. Worktop Control panel Detergent dispenser After-Service sticker (inside door) Door Child safety (inside door) Filter (inside compartment door) Plinth Adjustable feet. 1 2 3 4 5 6 7 8 9 Door 1. Pull the handle to open the double glass door. Close the door with light force, it will lock home audibly. 2.
4gb05103.fm Page 12 Thursday, August 14, 2003 11:57 AM Before The First Wash Cycle To remove any residual water used in testing by the manufacturer, we recommend that you carry out a short wash cycle without laundry. 1. Turn on the tap. 2. Close the door. 3. Pour a little detergent (about 30 ml) into the detergent compartment . 4. Select and start a short programme (see quick reference guide). Preparing The Wash 1. Sort the laundry according to...
4gb05103.fm Page 13 Thursday, August 14, 2003 11:57 AM Detergent And Additives The choice of detergent depends on: • type of fabric (cottons, easy care/synthetics, delicate items, wool). Note: Use only specific detergents for washing wool • colour • the wash temperature • degree and type of soiling Remarks: Whitish residues on dark fabrics are caused by insoluble compounds used in modern phosphate-free powder detergents. If this occurs, shake or brush out the fabric or use liquid detergents.
4gb05103.fm Page 14 Thursday, August 14, 2003 11:57 AM Filling the detergents and additives Chamber 1. Pull out the detergent dispenser to its full extent. 2. Fill the detergent: • Programme with pre and main wash • Main wash programme without prewash When using liquid detergent, remove the coloured insert from the detergent container and fit it in the chamber.
4gb05103.fm Page 15 Thursday, August 14, 2003 11:57 AM Removing The Filter We recommend that you check and clean the filter regularly, at least two or three times a year. Especially: • When the appliance does not drain or spin properly • If the pump is blocked by a foreign body (e.g. buttons, coins or safety pins) IMPORTANT: make sure the water has had time to cool before draining the appliance. 1. Switch off the appliance and unplug it. 2. Open the filter cover.
4gb05103.fm Page 16 Thursday, August 14, 2003 11:57 AM Care And Maintenance Appliance exterior and control panel • Can be washed down with a soft, damp cloth • A little neutral cleaner (not abrasive) can be used • Dry with a soft cloth Detergent dispenser Door seal Filter • Clean with a damp cloth when necessary • Check the seal folds for foreign bodies periodically • We recommend that you check and clean the filter regularly, at least two or three times a year see “Removing The Filter”) 1.
4gb05103.fm Page 17 Thursday, August 14, 2003 11:57 AM Troubleshooting Guide (Valid for all models except “LCD Intelligent Dialogue WAL....”) Depending on the model, your washing machine is equipped with various automatic safety functions. This enables faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes.
4gb05103.fm Page 18 Thursday, August 14, 2003 11:57 AM Fault display table Luminous display “Water tap” “Water Stop” Spin speed lights flash flash flash flash a. Fault in the water supply The appliance has no or insufficient water supply. For models with a fault display, the “Tap Off” display lights up and the spin speed indication LED flashes. If a digital display is fitted, “H” and “F” are also displayed alternately.
4gb05103.fm Page 19 Thursday, August 14, 2003 11:57 AM Then: 1. Plug in the appliance. 2. Turn the water tap on (if water immediately flows into the appliance again, without the appliance being started, there is a fault. Turn off the tap and notify After-Sales Service). 3. For models with fault display, select and start the desired programme again. For models with no fault display, continue the programme by pressing the “On/Off” button again.
4gb05103.fm Page 20 Thursday, August 14, 2003 11:57 AM Troubleshooting Guide (valid for all “LCD Intelligent Dialogue WAL.....” models) Depending on the model, your washing machine is equipped with various automatic safety functions. This enables faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes. The appliance will not start, no display is visible.
4gb05103.fm Page 21 Thursday, August 14, 2003 11:57 AM The water is not pumped out of the washing machine. The notice “FP” appears in the display. Switch the appliance off and pull out the mains plug. Check whether: • the drain hose is kinked • the pump or the filter is blocked (see “Removing The Filter”) IMPORTANT: Before emptying ensure that the water has cooled down. • the water in the drain hose is frozen up Reconnect the appliance to the electrical socket.
4gb05103.fm Page 22 Thursday, August 14, 2003 11:57 AM After-Sales Service Before contacting AfterSales Service: 1. Try to remedy the problem yourself (see “Troubleshooting Guide”). 2. Restart the programme to check whether the problem has solved itself. 3. If the washing machine continues to function incorrectly, call After-Sales Service.
4gb05103.fm Page 23 Thursday, August 14, 2003 11:57 AM Electrical connection 1) For Great Britain only 2) For the Republic of Ireland only Warning - this appliance must be earthed The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A.