i -- I I WASHER 1-93 Part No. 3347017 Rev. A I ,llt.ln Ovens and Surlace Units. Ranpes, Microwave Ovens. Compaclors. Room Au Condllmners. Dehumldlhers. Aulomatlc Washers. Clolhers Dryers. Freezers. Relr~geralor.Freezers. Ice Makers. Dlshusshen. Bu~ll-In Ovens and Suriace Umls. Rsnpes. Microwave Ovens. Compaclorr, Room Air Condilioners. Dehumidiliers.
Before you start... Untape and open washer IId Remove packages, hoses, and literature rack from washer Check location washer will ,I I^ where I,,, De ~nstallea Proper lnstallatlon Is your responsibility Make sure you have everything necessary for correct installation I Grounded electrical outlet ISrequired. See Electrical requirements. 4!!3* P 1 Hot and cold water faucets: must be withln 4 feet (122 A 1 centimeters) of the back of the washer and provide water pressure 5-100 PSI (34.5-689.6 KPa).
-- auuw awn... With Washer in Laundry Area. Numbers correspond to steps. 1 Remove tape that covers H shipping strap. Pull to completely remove the shipping strap from the inside of the washer. Read, then remove label that covers power cord and drain connector. Peel the tape down and off each side of cabinet. Pull firmly to remove the other end of the shipping strap from the back of the washer. The shipping strap plug must be completely removed from the washer for the self-leveling legs to be released.
19 CHECK ELECTRICAL n REQUIREMENTS. BESURE Y&l HAVECORRECTELECTRICAL SUPPLYAND RECOMMENDED GROUNDING METHOD. into correct holes at each front corner of washer until nuts touch washer. Do not tighten nuts until step 17. 15. . _4 Tilt washer backward and remove corner post(s). Gently lower washer to floor. Move washer to its permanent location. 20 Check that all parts are n now installed. See parts list, Panel A. If there is an extra part, go back through steps to see which step was skipped.
r’ .6 1 N Part No. 3347017 Rev. A Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022 Printed in U.S.A.