Use and Care Manual

14
9. Replace burner bases and burner caps.
The igniter electrode is ceramic and could break during
conversion. Be sure that the electrode comes through the hole
in the burner smoothly while you are replacing the burner
base.
A
B
C
A. Burner cap
B. Electrode
C. Burner base
10. Open shutoff valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
11. Plug in cooktop or reconnect power.
REMEMBER: Once you have completed converting all of the
cooktop burners, test the cooktop for leaks by brushing on an
approved noncorrosive leak-detection solution. If bubbles appear,
a leak is indicated. Correct any leaks found.
12. To adjust single and dual valves, see the “Complete
Installation” section.
Convert from Propane Gas to
Natural Gas
1. Turn manual shut-off valve to the closed position.
A
B
C
A. To cooktop
B. Shut-off valve (closed position)
C. Gas supply line
2. Unplug cooktop or disconnect power.
To Convert Gas Pressure Regulator
A
B
C
D
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
D. Gas flow
3. Determine the type of regulator you have:
Style 1: The cap has a slot and “LP” printed on it.
Remove access cap by using a flat-blade screwdriver or coin,
turning the access cap counterclockwise.
The gas pressure regulator has two settings which are
stamped on either side of the cap. Turn the cap and reinstall
into regulator with the stamp “NAT” visible from the outside of
the regulator.
NAT
Style 2: The access cap has a slot in it or a hex shape,
without any printed text.
Remove the access cap by using a flat-blade screwdriver or
wrench turning the access cap counter clockwise.
If Seven Universe is printed on the regulator, unthread the
spring retainer by rotating it counter clockwise. If Maxitrol is
printed on the regulator then apply force to the flat side of the
spring retainer to remove it.
Turn over the spring retainer to place the disk on the spring
retainer close to the access cap.
Install the Seven Universe spring retainer by turning it
clockwise to thread it fully into the access cap, or for the
Maxitrol spring retainer by applying pressure to snap the
spring retainer into the access cap.
Reinstall the cap and seal onto the regulator by turning
clockwise.
A
B
C
D
E F
A. Access cap
B. Seal
C. Regulator
D. Disk on Spring
Retainer
E. Spring Retainer in LP Gas
Position
F. Spring Retainer in Natural
Gas Position