Use and Care Manual
Table Of Contents
- COOKTOP SAFETY
- Cooktop Safety
- COOKTOP MAINTENANCE AND CARE
- General Cleaning
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Electrical Requirements
- Gas Supply Requirements
- INSTALLATION
- Install Cooktop
- Make Gas Connection
- Complete Installation
- GAS CONVERSIONS
- Convert from Natural Gas to Propane Gas
- Convert from Propane Gas to Natural Gas
- Lighting the Electronic Igniters
- Low Flame Height Adjustment
- Complete Burner Adjustment
- Moving the Cooktop
- SÉCURITÉ DE LA TABLE DE CUISSON
- Sécurité de la table de cuisson
- ENTRETIEN ET RÉPARATION DE LA TABLE DE CUISSON
- Nettoyage général
- INSTRUCTIONS D’INSTALLATION
- SPÉCIFICATIONS
- Outils et pièces
- Exigences d’emplacement
- Spécifications électriques
- Spécifications de l’alimentation en gaz
- INSTALLATION
- Installation de la table de cuisson
- Raccordement au gaz
- Achever l’installation
- CONVERSIONS POUR CHANGEMENT DE GAZ
- Conversion du gaz naturel au propane
- Conversion pour changement de gaz propane au gaz naturel
- Allumeurs électroniques – allumage
- Réglage pour le débit thermique minimum
- Achever le réglage des brûleurs
- Déplacement de la table de cuisson
17
3. The flame size can be increased or decreased by turning the
screw. Adjust flame until you can quickly turn the control knob
from the H to L position without extinguishing the flame. The
flame should be as small as possible without going out.
NOTE: For higher altitudes, no further burner adjustments are
necessary.
Complete Burner Adjustment
1. Check burner flame(s) for proper size and shape. The cooktop
low burner flame should be a steady blue flame approximately
1/4" (6.4 mm) high.
A. Low flame
B. High flame
2. Completely fill out the conversion label and attach label to
bottom of the cooktop next to the rating tag. Do not cover the
rating tag with the conversion label.
IMPORTANT:
Place gas orifice spuds in plastic parts bag for future use and
keep with package containing literature.
Read “Sealed Surface Burners” section in the Online Control
Guide.
.
Moving the Cooktop
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or electrical shock.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 14ʺ (36 cm) water
column.
Examples of a qualified person include: licensed heating
personnel, authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
If removing the cooktop is necessary for cleaning or maintenance:
1. Disconnect Power.
2. Shut gas line off.
3. Disconnect the flexible stainless steel connector.
4. Unscrew mounting brackets.
5. Using two or more people, place the cooktop on a covered
surface.
6. Complete cleaning or maintenance.
7. Reinstall cooktop using the “Install Cooktop” section of your
Owner’s Manual.