INSTALLATION INSTRUCTIONS DROP-IN ELECTRIC RANGE Table of Contents RANGE SAFETY INSTALLATION REQUIREMENT: Tools and Parts Location Requirements Electrical Requirements Counter top Preparation INSTALLATION INSTRUCTIONS install Anti-Tip Bracket Adjust Leveling Lags Electrical Connection Verify Anti-Tip Bracket Location Level Range... install Lower Trim Complete Installation Moving the Range... BRO TANDOORI Gm OR B® IMPORTANT: Save for local electrical inspector's use.
RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safely messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.
INSTALLATION REQUIREMENTS Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed wu Tape measures Level a Wrench or pliers u Hand or electric drill m Phillips screwdriver wm %° (3.2 mm) drill bit Flat-blade screwdriver Parts supplied Hack that all parts are included.
Cabinet Dimensions Cabinet opening dimensions shown are for 25" (84.0 om} counter top depth, 24” (61 cm) base cabinet depth and 36" {91.4 om) counter top height. IMPORTANT: if installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cook top surface. > cd L—7° upper cabinet F duration box depth min, from either cabinet, B.30" (76.2 cm) min. opening 81a" 21 cm) ma.
Confessional The cook top sides of the drop-in range fit over the cutout edge of your counter top. If you have a square finish flat) counter top and the opening width is 30" {76.2 mommy. ho counter top preparation is required. Formed front-edged counter tops must have molded edge shaved flat 38" (1.0 cm} from sate front corner of opening. Tile counter tops may dean trim cut back %" {1.0 cm) from each front corner and/or rounded edge flattened. ior PTE wr (76.2 om) so + (78.
Acs leveling Legs 1. if range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs. This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position. NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or mare people, stand range back up onto the cardboard of hardboard.
ER 4-Wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply where focal codes do not allow grounding through neutral, New Branch circuit installations (1996 NECK, mobile homes, recreational vehicles, and new construction, Connect the 2 black wires {CG} together using a UL listed wire connector. Connect the 2 white wires (D} and the green (or bare) ground wire (of the range cable) using a UL listed wire connector.
A. Screws 8 Lower rim piece Lorgnette isolation AN NEI Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. Check that you have all of your tools. Dispose off recycle all packaging materials. Hack that the range is level. See “Level Range.” Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth.