Installation Instructions

26
ADDITIONAL TIPS
Expect longer wash times. Your new dishwasher will average
2-5 hours per load but use nearly 40% less energy than older
models. Designed with a low wattage, low energy consumption
motor, your dishwasher washes longer to ensure exceptional
cleaning. Certain models are equipped with an optical water
sensor, so the first cycle will run longer to calibrate to optical
sensor. Selecting certain options could increase cycle time
past 3.5 hours.
Rinse Aid is necessary for good drying results:
This dishwasher is designed to be used with rinse aid for good
drying performance and controlling hard water deposit buildup.
Energy efficient dishwashers use less water and energy, so
they depend on the water sheeting action of rinse aid for good
drying performance.
Start/Resume light may flash:
When pressing Start/Resume, you must make sure the door
is closed within 3 seconds. If you do not close the door within
3 seconds, the Start/Resume light will flash until you press it
again. (You must also do this when adding a dish during the
middle of a cycle.)
CHECK OPERATION
Read the dishwasher User Guide that came with
your dishwasher.
Check that all parts have been installed and no steps
were skipped. Check that you have all tools used.
If the dishwasher is not working properly, disconnect power
or unplug dishwasher and refer to the “If Dishwasher Does
Not Operate” section.
IF DISHWASHER DOES NOT OPERATE
First try the solutions suggested here to possibly avoid the cost
of a service call.
Has the circuit breaker tripped or the house fuse blown?
Is the door closed tightly and latched?
Has the cycle been set correctly to start the dishwasher?
Is the water turned on?
If none of these possible solutions work, please see the
User Guide for service contact information.