Installation Instructions

20
DIRECT WIRE CONNECTION
Using a
1
/
4
" hex-head socket, nut driver, or Torx
®
T20
®
screwdriver, remove terminal box cover. Retain for later use.
Install a UL Listed/CSA Approved metallic strain relief.
See the “Tools and Parts” section at the front of the guide
for part details and orders.
Route cable so that it does not touch dishwasher motor or
lower part of dishwasher tub. Pull cable through UL Listed/
CSA Approved strain relief in terminal box. Strain relief is not
supplied with the dishwasher. Owner must purchase a
7
/
8
"
screw-in type strain relief.
Select UL Listed/CSA Approved twist-on wire connectors (not
included) rated to connect your household wiring to 16-gauge
dishwasher wiring.
49. Remove terminal box cover
50. Install strain relief
51. Route cable into terminal box
IMPORTANT: Check that top of door does not contact screws,
brackets, or countertop. If it does, adjust leveling legs or use
the side attachment option.
Open door and check that space between dishwasher cabinet
opening, and tub is equal on both sides. If spacing is not equal,
loosen bracket screws and shift tub. Tighten bracket screws.
47. Check door clearance
48. Check inner spacing