Service Manual
Table Of Contents
- W11187658-18" & 24" ADA Models Built-In Dishwashers
- Table of Contents
- Section 1: General Information
- Section 2: Diagnostics & Troubleshooting
- Section 3: Testing
- Section 4: Component Access
- Removing the Tub Gasket and Trim
- Removing the Outer Door Panel
- Removing the Control Panel
- Removing Door Switch Assembly
- Removing Dispenser Assembly
- Replacing the Inner Door Panel
- Removing the Air Breaker Assembly
- Removing the Nozzle Duct
- Removing the Control Board
- Removing the Water Valve
- Under Tub Components
- Removing the Pressure Switch
- Removing the Drain Pump
- Removing the Thermistor & Turbidity Sensor
- Removing the Heating Element
- Removing the Wash Pump Assembly
- Removing the Sump Assembly
- Product Specifications & Warranty Information
4-4
n
18” & 24” ADA Built-In Dishwashers
COMPONENT ACCESS
Removing the Control Panel
1. Unplug dishwasher or disconnect power.
2. Perform the procedures on page 4-2, “Remove Outer Door
Panel” prior to performing the following steps.
3. Remove the eight (8) screws indicated in Figure 1.
Figure 1
4. Disconnect the User Interface harness and remove the
handle cover. See Figure 2.
5. Remove the two (2) screws (indicated in Figure 2) to
remove the User Interface PCBA.
Disconnect UI Harness
Figure 2
Removing the Control Panel
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.