Service Manual
Table Of Contents
- W11187658-18" & 24" ADA Models Built-In Dishwashers
- Table of Contents
- Section 1: General Information
- Section 2: Diagnostics & Troubleshooting
- Section 3: Testing
- Section 4: Component Access
- Removing the Tub Gasket and Trim
- Removing the Outer Door Panel
- Removing the Control Panel
- Removing Door Switch Assembly
- Removing Dispenser Assembly
- Replacing the Inner Door Panel
- Removing the Air Breaker Assembly
- Removing the Nozzle Duct
- Removing the Control Board
- Removing the Water Valve
- Under Tub Components
- Removing the Pressure Switch
- Removing the Drain Pump
- Removing the Thermistor & Turbidity Sensor
- Removing the Heating Element
- Removing the Wash Pump Assembly
- Removing the Sump Assembly
- Product Specifications & Warranty Information
COMPONENT ACCESS
18” & 24” ADA Built-In Dishwashers
n
4-11
Removing the Water Valve
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Remove the Water Valve
The water valve is mounted on a bracket located on the le
side of the front brace.
1. Unplug dishwasher or disconnect power.
2. Remove the two (2) screws on the kick board (toe panel).
See Figure 1.
3. Remove the two (2) screws on insulang panel (see Figure
1).
Figure 1
4. Remove the 2 screws that hold the water valve to the
front brace (see Figure 2).
5. Remove the xing at just like the picture below.
Figure 2
6. Disconnect the wire from the solenoid (see Figure 3).
7. Remove the clamp and the outlet hose from the water
valve (see Figure 3).
Remove Hose & Clamp
Disconnect Harness
Figure 3
IMPORTANT: The clamp is easily damaged during removal
and should not be reused. Use the screw-type hose clamp
provided with the new valve.