Instructions for use WASHER-DRYER ! GB English, 1 This symbol reminds you to read this booklet.
Installation GB ! Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washing machine to inform the new owner as to its operation and features. ! Read these instructions carefully: they contain vital information on installation, use and safety. Unpacking and levelling Unpacking ! This is a separate part of the polystyrene base and should be removed with the base.
Connecting the drain hose 65 - 100 cm Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; • the supply voltage is included within the values indicated on the Technical details table (see page 5); GB • the socket is compatible with the washing machine’s plug. If this is not the case, replace the socket or the plug.
GB As the colours of the wires in the lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked E or or coloured Green or Green & Yellow. Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board.
GB Technical data Model WDL 5290 P/G/A/K Dimensions width 59.5 cm height 85 cm depth 53.5 cm Capacity from 1 to 7 kg for the wash programme from 1 to 4 kg for the drying programme Electrical connections please refer to the technical data plate fixed to the machine Water connections maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.5 bar) drum capacity 52 litres Spin speed up to 1200 rotations per minute Energy rated Wash: programme 1; temperature 60°C; using a load of 7 kg.
Description of the Washer-dryer and starting a wash cycle GB Control panel WASH CYCLE PROGRESS indicator lights DRYING knob ON/OFF button TEMPERATURE knob DOOR LOCKED indicator light START/PAUSE Detergent dispenser drawer FUNCTION WASH CYCLE button with indicator light buttons with indicator lights knob Detergent dispenser drawer: used to dispense detergents and washing additives (see “Detergents and laundry”). ON/OFF button: switches the Washer-dryer on and off.
Indicator lights The indicator lights provide important information. This is what they can tell you: Wash cycle phase indicator lights Once the desired wash cycle has been selected and has begun, the indicator lights switch on one by one to indicate which phase of the cycle is currently in progress.
Wash cycles Table of wash cycles Wash cycles GB Detergents Max. temp. (°C) Max. speed (rpm) Drying Essentials cycles 1 Cottons: extremely soiled whites. 90° 1200 1 Cottons (1): heavily soiled whites. 60° 1200 1 Cottons (2): lightly soiled whites and delicate colours. 40° 2 Cottons: heavily soiled whites and resistant colours. 60° Description of the wash cycle Max.
Personalisation Setting the temperature Turn the TEMPERATURE knob to set the wash temperature (see Table of wash cycles). The temperature may be lowered, or even set to a cold wash ( ). The Washer-dryer will automatically prevent you from selecting a temperature which is higher than the maximum value set for each wash cycle. Setting the drying cycle Table of Drying times (guideline values) Turn the DRYING knob to set the desired drying type. Fabric Max.
Detergents and laundry GB Detergent dispenser drawer Garments requiring special care Good washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact a build up on the inside of your appliance and contribute to environmental pollution.
Precautions and tips ! This Washer-dryer was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. • Do not use the appliance to dry foam rubber or similar elastomers. • Make sure that the water tap is turned on during the drying cycles. General safety Disposal • This appliance was designed for domestic use only.
Care and maintenance GB Cutting off the water and electricity supplies • Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the Washer-dryer and help to prevent leaks. To access the pre-chamber: 1. using a screwdriver, remove the cover panel on the lower front part of the washing machine (see figure); • Unplug the Washer-dryer when cleaning it and during all maintenance work.
Troubleshooting Your Washer-dryer could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be not solved easily using the following list. Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. • There is no power to the socket, or the fuse has blown in the mains plug. The wash cycle does not start. • • • • • The machine does not dry.
GB The machine leaks from the dispenser. • The dispenser drawer is blocked with detergent and requires cleaning. • The water pressure is too high and requires turning down - turn down the tap on the water supply pipe slightly and try again. • The machine is tilting forwards - It must be level when in its final position. The machine leaks (other than dispenser). • The fill hose is loose, check both the cabinet and tap ends.
Assistance Guarantee GB 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you.
195085581.03 09/2010 - Xerox Fabriano After Sales Service GB No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1000 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08448 224 224 Republic of Ireland: 0818 313 413 www.hotpointservice.co.