Installation guide

iNSTALLATiON

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed here.

Tools needed:

REQUIREMENTS

Flat-blade screwdriver

Wire stripper

(direct wire installations)

1/4" nut driver

(recommended)

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

#2 Phillips screwdriver

Tin snips

(new vent installations)

Vent clamps

Utility knife

Level

Caulking gun and

compound (for installing

new exhaust vent)

Parts supplied (all models):

Leveling legs (4)

Parts package is located in dryer drum. Check that all parts

are included.

Parts needed:

Check local codes. Check existing electrical supply and venting,

and read "Electrical Requirements" and "Venting Requirements"

before purchasing parts.

Mobile home installations require metal exhaust system hardware,

available for purchase from the dealer from whom you purchased

your dryer. For further information, please reference the

"Assistance or Service" section of the "Use and Care Guide".

If using a power supply cord:

Use a UL listed power supply cord kit marked for use with

clothes dryers. The kit should contain:

[] A UL listed 30-amp power supply cord, rated 120/240 volt

minimum. The cord should be type SRD or SRDT and be

at least 4 ft. (1.22 m) long. The wires that connect to the

dryer must end in ring terminals or spade terminals with

upturned ends.

[] A UL listed strain relief.

Tape measure Pliers