Door Reversal Guide

2
7. Reinstall latch on opposite side
Using a T25
®
screwdriver, reinstall the latch plate on the opposite
side from which it was removed with the four screws removed
earlier.
8. Reinstall hinge assembly on opposite side
Flip over the inner door to the left. Using a T20
®
screwdriver,
reinstall the hinge assembly on the opposite side from which it was
removed.
9. Remove rotating assembly
Lift off inner door assembly. Using a Phillips screwdriver, remove
the two screws securing the rotating assembly to the door.
10. Reposition rotating assembly and tubing
Reposition rotating assembly and tubing 180° to opposite side of
the door.
11. Rotate assembly bottom and fasten
IMPORTANT: Make sure to swing hinge down in front of rotating
assembly (see Step 12).
Rotate bottom of assembly 180° towards you and secure assembly
with the two screws removed earlier, using a Phillips screwdriver.
Press tubing into indents and reinstall hinge assembly cover plate.
12. Reinstall inner door assembly
Position the door with the inside of the door facing up. Using a
Phillips screwdriver, reinstall the 10 screws removed earlier,
securing the inner door to the outer door.
13. Reinstall door on dryer
Doors with electrical wiring: Pull the wire through the front panel
opening before reinstalling the door. Insert the tabs on the hinge
into the mounting slot and slide down to engage the top tab.
Secure in place with the four T25
®
screws removed earlier.
14. Reconnect wiring (doors with electrical
wiring)
Plug in wire. Using a Phillips screwdriver, secure the rotating
assembly to the hinge with the screw removed earlier.
Troubleshooting
See your Owner’s Manual or visit our website and reference Frequently Asked Questions to possibly avoid the cost of a service call.